MB9BF104RPMC-GE1 Fujitsu Semiconductor America Inc, MB9BF104RPMC-GE1 Datasheet - Page 4

• Manufacturer Part Number: MB9BF104RPMC-GE1
• Description: IC MCU 32BIT 256KB FLASH 120LQFP
• Manufacturer: Fujitsu Semiconductor America Inc
• Series: FM3 MB9B100r

Specifications of MB9BF104RPMC-GE1

• Core Processor: ARM® Cortex-M3™
• Core Size: 32-Bit
• Speed: 80MHz
• Connectivity: CSIO, EBI/EMI, I²C, LIN, UART/USART
• Peripherals: DMA, LVD, POR, PWM, WDT
• Number Of I /o: 100
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 16x12b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 120-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Other names: 865-1117

4
MB9B100 Series
 Multi-function Timer (Max. 2unit)
 Quadrature Position/Revolution Counter (QPRC) (Max. 2unit)
 Dual Timer (Two 32/16bit Down Counter)
 Watch Counter
 External Interrupt Controller Unit
 Watch dog Timer (2channels)
The Multi-function timer is composed of the following blocks.
・ 16-bit free-run timer × 3ch/unit
・ Input capture × 4ch/unit
・ Output compare × 6ch/unit
・ A/D activating compare × 3ch/unit
・ Waveform generator × 3ch/unit
・ 16-bit PPG timer × 3ch/unit
The following function can be used to achieve the motor control.
・ PWM signal output function
・ DC chopper waveform output function
・ Dead time function
・ Input capture function
・ A/D convertor activate function
・ DTIF (Motor emergency stop) interrupt function
The Quadrature Position/Revolution Counter (QPRC) is used to measure the position of the position
encoder. Moreover, it is possible to use up/down counter.
・ The detection edge of the three external event input pins AIN, BIN and ZIN is configurable.
・ 16-bit position counter
・ 16-bit revolution counter
・ Two 16-bit compare registers
The Dual Timer consists of two programmable 32/16-bit down counters.
Operation mode is selectable from the followings for each channel.
・ Free-running
・ Periodic (=Reload)
・ One-shot
The Watch counter is used for wake up from power saving mode.
・ Interval timer: up to 64s(Max.)@ Sub Clock : 32.768kHz
・ Up to 16 external vectors
・ Include one non-maskable interrupt(NMI)
A watchdog timer can generate interrupts or a reset when a time-out value is reached.
MB9B100 series consists of two different watchdogs, a "Hardware" watchdog and a "Software" watchdog.
"Hardware" watchdog timer is clocked by low speed CR oscillator. Therefore,”Hardware" watchdog is
active in any power saving mode except STOP.
DS706-00007-1v0-E