FSBB15CH60C Fairchild Semiconductor, FSBB15CH60C Datasheet - Page 58

• Manufacturer Part Number: FSBB15CH60C
• Description: IC POWER MOD SPM 600V SPM27CC
• Manufacturer: Fairchild Semiconductor
• Series: SPM™r
• Type: IGBTr

Specifications of FSBB15CH60C

• Configuration: 3 Phase
• Current: 15A
• Voltage: 600V
• Voltage - Isolation: 2500Vrms
• Package / Case: SPM27CC
• Transistor Polarity: N Channel
• Dc Collector Current: 15A
• Collector Emitter Voltage Vces: 2V
• Power Dissipation Pd: 55W
• Collector Emitter Voltage V(br)ceo: 600V
• Operating Temperature Range: -40°C To
• Operating Temperature (max): 150C
• Operating Temperature (min): -40C
• Pin Count: 27
• Mounting: Through Hole
• Case Length: 44mm
• Case Height: 5.5mm
• Screening Level: Automotive
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

2008-03-03
Environment
6) When repacking devices, use antistatic containers. Unused devices should be stored no longer than
7) Do not allow external forces or loads to be applied to the devices while they are in storage.
1) When humidity in the working environment decreases, the human body and other insulators can
2) Be sure that all equipment, jigs and tools in the working area are grounded to earth.
3) Place a conductive mat over the floor of the work area, or take other appropriate measures, so that
4) Cover the workbench surface with a conductive mat, grounded to earth, to disperse electrostatic
5) Ensure that work chairs are protected with an antistatic textile cover and are grounded to the floor
6) Install antistatic mats on storage shelf surfaces.
7) For transport and temporary storage of devices, use containers that are made of antistatic materials
8) Make sure cart surfaces that come into contact with device packaging are made of materials that will
9) Operators must wear antistatic clothing and conductive shoes (or a leg or heel strap).
10) Operators must wear a wrist strap grounded to earth through a resistor of about 1M Ω .
11) If the tweezers you use are likely to touch the device terminals, use an antistatic type and avoid
12) When storing device-mounted circuit boards, use a board container or bag that is protected against
13) Ensure that articles (such as clip boards) that are brought into static electricity control areas are
14) In cases where the human body comes into direct contact with a device, be sure to wear finger
one month.
easily become charged with electrostatic electricity due to friction. Maintain the recommended
humidity of 40% to 60% in the work environment. Be aware of the risk of moisture absorption by the
products after unpacking from moisture-proof packaging.
the floor surface is grounded to earth and is protected against electrostatic electricity.
electricity on the surface through resistive components. Workbench surfaces must not be
constructed of low-resistance metallic material that allows rapid static discharge when a charged
device touches it directly.
surface with a grounding chain.
conduct static electricity, and are grounded to the floor surface with a grounding chain.
lead solderability will be degraded.
of materials that dissipate static electricity.
metallic tweezers. If a charged device touches such a low-resistance tool, a rapid discharge can
occur. When using vacuum tweezers, attach a conductive chucking pad at the tip and connect it to
a dedicated ground used expressly for antistatic purposes.
static charge. Keep them separated from each other, and do not stack them directly on top of one
another, to prevent static charge/discharge which occurs due to friction.
constructed of antistatic materials as far as possible.
cots or gloves protected against static electricity.
V4 Mini DIP SPM Application Note (2008-03-03)
58
FAIRCHILD SEMICONDUCTOR - Smart Power Module