UPD70F3736GK-GAK-AX Renesas Electronics America, UPD70F3736GK-GAK-AX Datasheet - Page 627

• Manufacturer Part Number: UPD70F3736GK-GAK-AX
• Description: MCU 32BIT V850ES/JX3-L 80-LQFP
• Manufacturer: Renesas Electronics America
• Series: V850ES/Jx3-Lr

Specifications of UPD70F3736GK-GAK-AX

• Package / Case: *
• Voltage - Supply (vcc/vdd): 2.2 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Speed: 20MHz
• Number Of I /o: 66
• Core Processor: RISC
• Program Memory Type: FLASH
• Ram Size: 16K x 8
• Program Memory Size: 256KB (256K x 8)
• Data Converters: A/D 8x10b, D/A 1x8b
• Oscillator Type: Internal
• Peripherals: DMA, LVD, PWM, WDT
• Connectivity: CSI, EBI/EMI, I²C, UART/USART
• Core Size: 32-Bit
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

(4) DMA transfer initialization procedure (setting DCHCn.INITn bit to 1)
Even if the INITn bit is set to 1 when the channel executing DMA transfer is to be initialized, the channel may
not be initialized. To accurately initialize the channel, execute either of the following two procedures.
(a) Temporarily stop transfer of all DMA channels
Initialize the channel executing DMA transfer using the procedure in <1> to <7> below.
Note, however, that TCn bit is cleared to 0 when step <5> is executed. Make sure that the other
processing programs do not expect that the TCn bit is 1.
<1> Disable interrupts (DI).
<2> Read the DCHCn.Enn bit of DMA channels other than the one to be forcibly terminated, and transfer
<3> Clear the Enn bit of the DMA channels used (including the channel to be forcibly terminated) to 0. To
<4> Set the INITn bit of the channel to be forcibly terminated to 1.
<5> Read the TCn bit of each channel not to be forcibly terminated. If both the TCn bit and the Enn bit
<6> After the operation in <5>, write the Enn bit value to the DCHCn register.
<7> Enable interrupts (EI).
Caution Be sure to execute step <5> above to prevent illegal setting of the Enn bit of the channels
the value to a general-purpose register.
clear the Enn bit of the last DMA channel, execute the clear instruction twice. If the target of DMA
transfer (transfer source/destination) is the internal RAM, execute the instruction three times.
read in <2> are 1 (logical product (AND) is 1), clear the saved Enn bit to 0.
Example: Execute instructions in the following order if channels 0, 1, and 2 are used (if the target of
whose DMA transfer has been normally completed between <2> and <3>.
transfer is not the internal RAM).
• Clear DCHC0.E00 bit to 0.
• Clear DCHC1.E11 bit to 0.
• Clear DCHC2.E22 bit to 0.
• Clear DCHC2.E22 bit to 0 again.
CHAPTER 18 DMA FUNCTION (DMA CONTROLLER)
Preliminary User’s Manual U18952EJ1V0UD
627