HD6417727BP160CV Renesas Electronics America, HD6417727BP160CV Datasheet - Page 335

• Manufacturer Part Number: HD6417727BP160CV
• Description: IC SH MPU ROMLESS 240BGA
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7700r

Specifications of HD6417727BP160CV

• Core Processor: SH-3 DSP
• Core Size: 32-Bit
• Speed: 160MHz
• Connectivity: FIFO, SCI, SIO, SmartCard, USB
• Peripherals: DMA, LCD, POR, WDT
• Number Of I /o: 104
• Program Memory Type: ROMless
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 1.7 V ~ 2.05 V
• Data Converters: A/D 6x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 240-BGA
• Package: 240CSP
• Family Name: SuperH
• Maximum Speed: 160 MHz
• Operating Supply Voltage: 1.8|3.3 V
• Data Bus Width: 32 Bit
• Number Of Programmable I/os: 104
• Interface Type: SCI/USB
• On-chip Adc: 6-chx10-bit
• On-chip Dac: 2-chx8-bit
• Number Of Timers: 4
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -

10.8.4
When operating in interval timer mode, interval timer interrupts are generated at every overflow of
the counter. This enables interrupts to be generated at set periods.
1. Clear the WT/IT bit in the WTCSR register to 0, set the type of count clock in the CKS2 to
2. Set the TME bit in WTCSR to 1 to start the count in interval timer mode.
3. When the counter overflows, the WDT sets the IOVF flag in WTCSR to 1 and an interval
10.9
When Using an External Crystal Resonator: Place the crystal resonator, capacitors CL1 and
CL2, and damping resistor R close to the EXTAL and XTAL pins. To prevent induction from
interfering with correct oscillation, use a common grounding point for the capacitors connected to
the resonator, and do not locate a wiring pattern near these components.
CKS0 bits, and set the initial value of the counter in the WTCNT counter.
timer interrupt request is sent to INTC. The counter then resumes counting.
Note: The values for CL1, CL2, and the damping resistance should be determined after
Using Interval Timer Mode
Notes on Board Design
consultation with the crystal resonator manufacturer.
Figure 10.4 Points for Attention when Using Crystal Resonator
EXTAL
Avoid crossing
signal lines
CL1
SH7727
CL2
XTAL
R
Rev.6.00 Mar. 27, 2009 Page 277 of 1036
Section 10 On-Chip Oscillation Circuits
REJ09B0254-0600