HD64F3067RF20 Renesas Electronics America, HD64F3067RF20 Datasheet - Page 637

• Manufacturer Part Number: HD64F3067RF20
• Description: IC H8 MCU FLASH 128K 100-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300Hr

Specifications of HD64F3067RF20

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: SCI, SmartCard
• Peripherals: DMA, PWM, WDT
• Number Of I /o: 70
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-QFP
• Package: 100PQFP
• Family Name: H8
• Maximum Speed: 20 MHz
• Operating Supply Voltage: 5 V
• Data Bus Width: 16|32 Bit
• Number Of Programmable I/os: 70
• Interface Type: SCI
• On-chip Adc: 8-chx10-bit
• On-chip Dac: 2-chx8-bit
• Number Of Timers: 7
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Bit 6—Software Write Enable Bit (SWE) *
programming/erasing. This bit should be set before setting FLMCR bits 5 to 0, and EBR bits 7 to
0. Do not set the ESU, PSU, EV, PV, E, or P bits at the same time.
Bit 6:
SWE
0
1
Bit 5—Erase Setup Bit (ESU) *
PSU, EV, PV, E, or P bit at the same time.
Bit 5:
ESU
0
1
Bit 4—Program Setup Bit (PSU) *
SWE, ESU, EV, PV, E, or P bit at the same time.
Bit 4:
PSU
0
1
Description
Program/erase disabled
Program/erase enabled
[Setting condition]
When FWE = 1
Description
Erase setup cleared
Erase setup
[Setting condition]
When FWE = 1, and SWE = 1
Description
Program setup cleared
Program setup
[Setting condition]
When FWE = 1, and SWE = 1
1
: Prepares for a transition to erase mode. Do not set the SWE,
1
: Prepares for a transition to program mode. Do not set the
1
*
2
: This bit enables/disables flash memory
Rev. 4.00 Jan 26, 2006 page 613 of 938
REJ09B0276-0400
Section 18 ROM
(Initial value)
(Initial value)
(Initial value)