DF2367VF33V Renesas Electronics America, DF2367VF33V Datasheet - Page 362

• Manufacturer Part Number: DF2367VF33V
• Description: IC H8S/2367 MCU FLASH 128QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of DF2367VF33V

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 33MHz
• Connectivity: I²C, IrDA, SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 84
• Program Memory Size: 384KB (384K x 8)
• Program Memory Type: FLASH
• Ram Size: 24K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 10x10b, D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 128-QFP
• For Use With: YR0K42378FC000BA - KIT EVAL FOR H8S/2378HS0005KCU11H - EMULATOR E10A-USB H8S(X),SH2(A)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Section 8 Data Transfer Controller (DTC)
Source flag cleared
Clear
controller
Clear
DTCER
Clear request
Select
On-chip
DTC
supporting
module
IRQ interrupt
Interrupt
request
CPU
Interrupt controller
DTVECR
Interrupt mask
Figure 8.2 Block Diagram of DTC Activation Source Control
8.4
Location of Register Information and DTC Vector Table
Locate the register information in the on-chip RAM (addresses: H'FFBC00 to H'FFBFFF).
Register information should be located at the address that is multiple of four within the range.
Locating the register information in address space is shown in figure 8.3. Locate the MRA, SAR,
MRB, DAR, CRA, and CRB registers, in that order, from the start address of the register
information. In the case of chain transfer, register information should be located in consecutive
areas as shown in figure 8.3 and the register information start address should be located at the
corresponding vector address to the activation source. Figure 8.4 shows the correspondence
between the DTC vector address and register information. The DTC reads the start address of the
register information from the vector address set for each activation source, and then reads the
register information from that start address.
When the DTC is activated by software, the vector address is obtained from: H'0400 +
(DTVECR[6:0] × 2). For example, if DTVECR is H'10, the vector address is H'0420.
The configuration of the vector address is the same in both normal* and advanced modes, a 2-byte
unit being used in both cases. These two bytes specify the lower bits of the register information
start address.
Note: * Not available in this LSI.
Rev.6.00 Mar. 18, 2009 Page 302 of 980
REJ09B0050-0600