R4F24268NVFQV Renesas Electronics America, R4F24268NVFQV Datasheet - Page 515

• Manufacturer Part Number: R4F24268NVFQV
• Description: MCU 256K FLASH 48K 144-LQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2400r

Specifications of R4F24268NVFQV

• Core Processor: H8S/2600
• Core Size: 16/32-Bit
• Speed: 33MHz
• Connectivity: EBI/EMI, I²C, IrDA, SCI, SSU, UART/USART
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 96
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 48K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 10x10b, D/A 2x8b
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 144-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

H8S/2426, H8S/2426R, H8S/2424 Group
9.4
Locate the register information in the on-chip RAM (addresses: H'FFBC00 to H'FFBFFF).
Register information should be located at the address that is multiple of four within the range.
Locating the register information in address space is shown in figure 9.3. Locate the MRA, SAR,
MRB, DAR, CRA, and CRB registers, in that order, from the start address of the register
information. In the case of chain transfer, register information should be located in consecutive
areas as shown in figure 9.3 and the register information start address should be located at the
corresponding vector address to the activation source. Figure 9.4 shows correspondences between
the DTC vector address and register information. The DTC reads the start address of the register
information from the vector address set for each activation source, and then reads the register
information from that start address.
When the DTC is activated by software, the vector address is obtained from: H'0400 +
(DTVECR[7:0] × 2). For example, if DTVECR is H'10, the vector address is H'0420.
The configuration of the vector address is the same in both normal* and advanced modes, a 2-byte
unit being used in both cases. These two bytes specify the lower bits of the register information
start address.
Note: * Not available in this LSI.
REJ09B0466-0350 Rev. 3.50
Jul 09, 2010
Figure 9.3 Correspondence between DTC Vector Address and Register Information
Start address of
register information
Chain transfer
Location of Register Information and DTC Vector Table
MRA
MRA
MRB
MRB
0
CRA
CRA
Lower addresses
1
Four bytes
DAR
DAR
SAR
SAR
2
CRB
CRB
Section 9 Data Transfer Controller (DTC)
3
Register information
Register information
for second transfer
in case of chain
transfer
Page 485 of 1372