R4F24268NVFQV Renesas Electronics America, R4F24268NVFQV Datasheet - Page 1193

• Manufacturer Part Number: R4F24268NVFQV
• Description: MCU 256K FLASH 48K 144-LQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2400r

Specifications of R4F24268NVFQV

• Core Processor: H8S/2600
• Core Size: 16/32-Bit
• Speed: 33MHz
• Connectivity: EBI/EMI, I²C, IrDA, SCI, SSU, UART/USART
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 96
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 48K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 10x10b, D/A 2x8b
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 144-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

H8S/2426, H8S/2426R, H8S/2424 Group
23.5
23.5.1
In software standby mode, I/O port states are retained. Therefore, there is no reduction in current
dissipation for the output current when a high-level signal is output.
23.5.2
Current dissipation increases during the oscillation stabilization standby period.
23.5.3
Depending on the operating status of the EXDMAC, DMAC, or DTC, the MSTP14 to MSTP13
and may not be set to 1. Setting of the EXDMAC, DMAC, or DTC module stop state should be
carried out only when the respective module is not activated.
For details, see section 8, EXDMA Controller (EXDMAC), section 7, DMA Controller (DMAC),
and section 9, Data Transfer Controller (DTC).
Note: The EXDMAC is not supported by the H8S/2424 group.
23.5.4
Relevant interrupt operations cannot be performed in the module stop state. Consequently, if the
module stop state is entered when an interrupt has been requested, it will not be possible to clear
the CPU interrupt source or the DMAC or DTC activation source.
Interrupts should therefore be disabled before entering the module stop state.
Note: The EXDMAC is not supported by the H8S/2424 group.
23.5.5
MSTPCR, EXMSTPCR, and RMMSTPCR should only be written to by the CPU.
REJ09B0466-0350 Rev. 3.50
Jul 09, 2010
Usage Notes
I/O Port Status
Current Dissipation during Oscillation Stabilization Standby Period
EXDMAC, DMAC, and DTC Module Stop
On-Chip Peripheral Module Interrupts
Writing to MSTPCR, EXMSTPCR, and RMMSTPCR
Section 23 Power-Down Modes
Page 1163 of 1372