CV500BC051 Omron, CV500BC051 Datasheet - Page 97

• Manufacturer Part Number: CV500BC051
• Description: Programmable Logic Controller
• Manufacturer: Omron

Specifications of CV500BC051

• Peak Reflow Compatible (260 C): No
• Leaded Process Compatible: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

72
Wiring
Note
1. Always turn OFF the power to the PLC before connecting the communica-
2. Always use a crimp terminal for wiring. If a wire that has only been twisted
3. Use the recommended crimp terminals.
4. When mounting the crimp terminal, always use the appropriate tools for
5. Measure the length of peeled cable during installation according to the
6. Be sure not to confuse the signal lines and shield line connections.
7. Tighten the screws on the terminal block firmly. The correct tightening
8. If a signal line disconnects from the terminal, either the Unit will be unable
9. Do not pull on a communication cable.
tions cables.
is connected directly to a terminal block, short circuit, malfunction and
product damage will result.
each crimp terminal and follow the appropriate installation procedures.
Contact the crimp terminal manufacturer for details on the appropriate
tools and procedures. Failure to use the appropriate tools and procedures
could cause cables to break.
crimp terminal used and make sure that the peeled length is not too long.
Cover the compressed section of the crimp terminal and cable with vinyl
tape or heat-shrinking tube.
torque is 0.5 N·m.
to communicate with other nodes on the network or that section of the net-
work will be isolated from other nodes. Be sure not to pull on the signal
lines.
b) The approximate dimension for when the cable has been wired
from the terminal block along the front of the Unit is shown in the
following diagram.
Controller Link Unit
Isolated
(Transmission not possible)
25 mm max.
Transmission
not possible
Section 3-3