CV500BC051 Omron, CV500BC051 Datasheet - Page 92

• Manufacturer Part Number: CV500BC051
• Description: Programmable Logic Controller
• Manufacturer: Omron

Specifications of CV500BC051

• Peak Reflow Compatible (260 C): No
• Leaded Process Compatible: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Unit Installation
Screw-mounting a Repeater Unit
Mounting a Repeater Unit on DIN Track
DIN Track
1,2,3...
Use M4 × 15 screws to mount the Unit as shown in the following diagram.
1. Unlock the DIN Track mounting pins located on the rear of the Repeater
2. Attach the Repeater Unit by hooking it onto the DIN Track from above (1)
3. Lock all DIN Track mounting pins.
4. Secure the Repeater Unit by mounting one End Plate on each side of the
Mount the Repeater Unit to DIN Track. Use at least three screws to attach the
DIN Track to the control panel.
DIN Track: PFP-50N (50 cm), PFP-100N (100 cm), PFP-100N2 (100 cm)
The DIN Track should be attached within the control panel using M4 screws
spaced not more than 210 mm (not more than 6 holes) apart. Attach a DIN
Track in at least 3 points for the longest DIN Track length. Tightening torque
should be 1.2 N·m.
81 mm
Two, M4
Unit.
and then pressing it into place (2).
Unit. End Plates are attached by hooking first the bottom (1) then the top
of the Plate onto the DIN Track and pulling down (2). Use the screw on the
each End Plate to fasten it in place.
21 mm
DIN Track mounting pin
8 mm
Section 3-2
67