mt90870ag2 Zarlink Semiconductor, mt90870ag2 Datasheet - Page 9

• Manufacturer Part Number: mt90870ag2
• Description: Flexible 12 K Digital Switch F12kdx
• Manufacturer: Zarlink Semiconductor

Changes Summary
The following table captures the changes from the December 2002 issue.
Page
14
21
23
23
24
25
26
27
52
53
54
73
Pin Description, C8i
Figure 6, Local Port Timing Diagram for
2,4,8 and 16 Mb/s stream rates
Figure 7, Backplane Port Timing Diagram
for 2, 4, 8, 16 and 32 Mb/s stream rates
Section 2.3. Backplane Frame Pulse Input
and Master Input Clock Timing
Figure 8, Backplane and Local Frame
Pulse Alignment for Data Rates of 2 Mb/s,
4 Mb/s, 8 Mb/s and 16 Mb/s
Figure 9, Backplane and Local Input
Channel Delay Timing Diagram (8 Mb/s)
Figure 10, Backplane and Local Input Bit
Delay Timing Diagram for Data Rate of
16 Mb/s
Figure 11, Backplane and Local Input Bit
Delay Timing Diagram for Data Rate of
8 Mb/s
Section 13.1. Control Register (CR) Bit 6,
C8IPOL
Figure 18, Frame Boundary Conditions,
ST- BUS Operation
Figure 19, Frame Boundary Conditions,
GCI - BUS Operation
Backplane and Local Clock Timing:
Item 2, Backplane Frame Pulse Setup
Time before C8i clock falling edge
Item 3, Backplane Frame Pulse Hold Time
from C8i clock falling edge
Item
Zarlink Semiconductor Inc.
MT90870
9
The internal frame boundary alignment description
is changed from the clock rising or falling edge to
rising edge only. Also added description to specify
setting the C8IPOL bit in the Control Register to
one for clock rising edge alignment operation.
Changed C8i frame boundary active edge from
falling to rising edge.
Changed C8i frame boundary active edge from
falling to rising edge.
Removed the falling clock edge frame boundary
alignment option.
Changed C8i frame boundary active edge from
falling to rising edge.
Changed FPo and C8o to FPi and C8i respectively
and showing rising C8i frame boundary active
edge.
Changed FPo and C8o to FPi and C8i respectively
and showing rising C8i frame boundary active
edge.
Changed FPo and C8o to FPi and C8i
respectively.
Changed description to specify Bit 6, C8IPOL
must be set high for rising clock edge frame
boundary alignment operation.
Removed waveforms showing C8i falling edge
frame boundary option.
Removed waveforms showing C8i falling edge
frame boundary option.
Item 2, Backplane Frame Pulse Setup Time
before C8i clock falling edge changed to
Backplane Frame Pulse Setup Time before C8i
clock rising edge.
Item 3, Backplane Frame Pulse Hold Time from
C8i clock falling edge changed to Backplane
Frame Pulse Hold Time from C8i clock rising
edge.
Change
Data Sheet