LM3S2110-IQN20-A0 Luminary Micro, Inc., LM3S2110-IQN20-A0 Datasheet - Page 402

• Manufacturer Part Number: LM3S2110-IQN20-A0
• Description: Microcontroller
• Manufacturer: Luminary Micro, Inc.

Pulse Width Modulator (PWM)
16.2.2
402
generating left- or right-aligned PWM signals, while the Count-Up/Down mode is used for generating
center-aligned PWM signals.
The timers output three signals that are used in the PWM generation process: the direction signal
(this is always Low in Count-Down mode, but alternates between Low and High in Count-Up/Down
mode), a single-clock-cycle-width High pulse when the counter is zero, and a single-clock-cycle-width
High pulse when the counter is equal to the load value. Note that in Count-Down mode, the zero
pulse is immediately followed by the load pulse.
PWM Comparators
There are two comparators in the PWM generator that monitor the value of the counter; when either
match the counter, they output a single-clock-cycle-width High pulse. When in Count-Up/Down
mode, these comparators match both when counting up and when counting down; they are therefore
qualified by the counter direction signal. These qualified pulses are used in the PWM generation
process. If either comparator match value is greater than the counter load value, then that comparator
never outputs a High pulse.
Figure 16-2 on page 402 shows the behavior of the counter and the relationship of these pulses
when the counter is in Count-Down mode. Figure 16-3 on page 403 shows the behavior of the counter
and the relationship of these pulses when the counter is in Count-Up/Down mode.
Figure 16-2. PWM Count-Down Mode
CompA
CompB
Load
Load
Zero
Zero
Dir
A
B
ADown
BDown
Preliminary
November 29, 2007