XC908AS60ACFU Motorola Semiconductor Products, XC908AS60ACFU Datasheet - Page 259

• Manufacturer Part Number: XC908AS60ACFU
• Description: MC68HC908AZ60A, MC68HC908AS60A Hcmos Microcontroller Unit Technical Data
• Manufacturer: Motorola Semiconductor Products

18.5.3.4 Framing Errors
18.5.3.5 Baud Rate Tolerance
MC68HC908AZ60A — Rev 2.0
MOTOROLA
If the data recovery logic does not detect a logic 1 where the stop bit
should be in an incoming character, it sets the framing error bit, FE, in
SCS1. A break character also sets the FE bit because a break character
has no stop bit. The FE bit is set at the same time that the SCRF bit is
set.
A transmitting device may be operating at a baud rate below or above
the receiver baud rate. Accumulated bit time misalignment can cause
one of the three stop bit data samples to fall outside the actual stop bit.
Then a noise error occurs. If more than one of the samples is outside the
stop bit, a framing error occurs. In most applications, the baud rate
tolerance is much more than the degree of misalignment that is likely to
occur.
As the receiver samples an incoming character, it resynchronizes the RT
clock on any valid falling edge within the character. Resynchronization
within characters corrects misalignments between transmitter bit times
and receiver bit times.
Slow Data Tolerance
Figure 18-9
misaligned without causing a noise error or a framing error. The slow
stop bit begins at RT8 instead of RT1 but arrives in time for the stop
bit data samples at RT8, RT9, and RT10.
RECEIVER
RT CLOCK
Serial Communications Interface (SCI)
shows how much a slow received character can be
MSB
Figure 18-9. Slow Data
SAMPLES
Serial Communications Interface (SCI)
DATA
STOP
Functional Description
Technical Data
259