ST7LITE49M STMicroelectronics, ST7LITE49M Datasheet - Page 139

• Manufacturer Part Number: ST7LITE49M
• Description: 8-bit MCU
• Manufacturer: STMicroelectronics

Specifications of ST7LITE49M

• 4 Kbytes Single Voltage Extended Flash (xflash) Program Memory With Read-out Protection In-circuit Programming And In-application Programming (icp And Iap) Endurance: 10k write/erase cycles guaranteed Data retention
• 128 Bytes Data Eeprom With Read-out Protection. 300k Write/erase Cycles Guaranteed, Data Retention: 20 years at 55 °C.
• Clock Sources: Internal trimmable 8 MHz RC oscillator, auto-wakeup internal low power - low frequency oscillator, crystal/ceramic resonator or external clock
• Five Power Saving Modes: Halt, Active-halt, Auto-wakeup from Halt, Wait and Slow
• A/d Converter: 10 input channels

ST7LITE49M
13
13.1
13.1.1
13.1.2
13.1.3
13.1.4
13.1.5
Electrical characteristics
Parameter conditions
Unless otherwise specified, all voltages are referred to V
Minimum and maximum values
Unless otherwise specified the minimum and maximum values are guaranteed in the worst
conditions of ambient temperature, supply voltage and frequencies by tests in production on
100% of the devices with an ambient temperature at T
the selected temperature range).
Data based on characterization results, design simulation and/or technology characteristics
are indicated in the table footnotes and are not tested in production. Based on
characterization, the minimum and maximum values refer to sample tests and represent the
mean value plus or minus three times the standard deviation (mean±3Σ).
Typical values
Unless otherwise specified, typical data are based on T
4.5 V≤V
They are given only as design guidelines and are not tested.
Typical curves
Unless otherwise specified, all typical curves are given only as design guidelines and are
not tested.
Loading capacitor
The loading conditions used for pin parameter measurement are shown in
Figure 60. Pin loading conditions
Pin input voltage
The input voltage measurement on a pin of the device is described in
DD
≤5.5 V voltage range) and V
C
Doc ID 13562 Rev 3
L
DD
= 3.3 V (for the 3.0 V≤V
ST7 PIN
A
A
= 25 °C and T
SS
= 25 °C, V
.
Electrical characteristics
DD
DD
≤3.6 V voltage range).
A
Figure
= 5 V (for the
= T
A
Figure
max (given by
61.
60.
139/188