SAM9G10 Atmel Corporation, SAM9G10 Datasheet - Page 625

• Manufacturer Part Number: SAM9G10
• Manufacturer: Atmel Corporation

Specifications of SAM9G10

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 266 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Ssc: 3
• Sd / Emmc: 1
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: No
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 16
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.08 to 1.32
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

SAM9G10
• RXRSM: UDP Resume Interrupt Status
0 = No UDP Resume Interrupt pending.
1 =UDP Resume Interrupt has been raised.
The USB device sets this bit when a UDP resume signal is detected at its port.
After reset, the state of this bit is undefined, the application must clear this bit by setting the RXRSM flag in the UDP_ICR
register.
• SOFINT: Start of Frame Interrupt Status
0 = No Start of Frame Interrupt pending.
1 = Start of Frame Interrupt has been raised.
This interrupt is raised each time a SOF token has been detected. It can be used as a synchronization signal by using
isochronous endpoints.
• ENDBUSRES: End of BUS Reset Interrupt Status
0 = No End of Bus Reset Interrupt pending.
1 = End of Bus Reset Interrupt has been raised.
This interrupt is raised at the end of a UDP reset sequence. The USB device must prepare to receive requests on the end-
point 0. The host starts the enumeration, then performs the configuration.
• WAKEUP: UDP Resume Interrupt Status
0 = No Wakeup Interrupt pending.
1 = A Wakeup Interrupt (USB Host Sent a RESUME or RESET) occurred since the last clear.
After reset the state of this bit is undefined, the application must clear this bit by setting the WAKEUP flag in the UDP_ICR
register.
627
6462B–ATARM–6-Sep-11