SAM9G10 Atmel Corporation, SAM9G10 Datasheet - Page 594

• Manufacturer Part Number: SAM9G10
• Manufacturer: Atmel Corporation

Specifications of SAM9G10

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 266 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Ssc: 3
• Sd / Emmc: 1
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: No
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 16
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.08 to 1.32
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

36.4
36.4.1
Figure 36-2. USB Host Communication Channels
596
Functional Description
SAM9G10
Host Controller Interface
Device Enumeration
Please refer to the Open Host Controller Interface Specification for USB Release 1.0.a.
There are two communication channels between the Host Controller and the Host Controller
Driver. The first channel uses a set of operational registers located on the USB Host Controller.
The Host Controller is the target for all communications on this channel. The operational regis-
ters contain control, status and list pointer registers. They are mapped in the memory mapped
area. Within the operational register set there is a pointer to a location in the processor address
space named the Host Controller Communication Area (HCCA). The HCCA is the second com-
munication channel. The host controller is the master for all communication on this channel. The
HCCA contains the head pointers to the interrupt Endpoint Descriptor lists, the head pointer to
the done queue and status information associated with start-of-frame processing.
The basic building blocks for communication across the interface are Endpoint Descriptors (ED,
4 double words) and Transfer Descriptors (TD, 4 or 8 double words). The host controller assigns
an Endpoint Descriptor to each endpoint in the system. A queue of Transfer Descriptors is linked
to the Endpoint Descriptor for the specific endpoint.
Open HCI
= Transfer Descriptor
Device Register
in Memory Space
Operational
Registers
Mode
HCCA
Status
Event
Frame Int
Ratio
Control
Bulk
Shared RAM
Host Controller
Communications Area
Interrupt 31
Interrupt 0
Interrupt 1
Interrupt 2
Done
. . .
. . .
. . .
= Endpoint Descriptor
6462B–ATARM–6-Sep-11