LAN9303-ABZJ SMSC, LAN9303-ABZJ Datasheet - Page 209

• Manufacturer Part Number: LAN9303-ABZJ
• Description: IC ETHER SW 3PORT 16BIT 56QFN
• Manufacturer: SMSC

Specifications of LAN9303-ABZJ

• Controller Type: Ethernet Switch Controller
• Interface: SMBus (2-Wire/I²C)
• Voltage - Supply: 3 V ~ 3.6 V
• Current - Supply: 190mA
• Operating Temperature: 0°C ~ 70°C
• Mounting Type: Surface Mount
• Package / Case: 56-QFN
• Product: Ethernet Switches
• Standard Supported: Yes
• Data Rate: 10 Mbps/100 Mbps
• Supply Voltage (max): 3.6 V
• Supply Voltage (min): 3 V
• Supply Current (max): 0.19 A (Typ)
• Maximum Operating Temperature: + 70 C
• Minimum Operating Temperature: 0 C
• Mounting Style: SMD/SMT
• For Use With: 638-1095 - EVALUATION BOARD FOR LAN9303
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 638-1082

Small Form Factor Three Port 10/100 Managed Ethernet Switch with Single MII/RMII/Turbo MII
Datasheet
SMSC LAN9303/LAN9303i
13.3.2.11
BITS
15:8
7
6
5
4
3
2
1
0
RESERVED
INT7
This interrupt source bit indicates when the
the
(PHY_MODE_CONTROL_STATUS_x)
0: Not source of interrupt
1: ENERGYON generated
INT6
This interrupt source bit indicates Auto-Negotiation is complete.
0: Not source of interrupt
1: Auto-Negotiation complete
INT5
This interrupt source bit indicates a remote fault has been detected.
0: Not source of interrupt
1: Remote fault detected
INT4
This interrupt source bit indicates a Link Down (link status negated).
0: Not source of interrupt
1: Link Down (link status negated)
INT3
This interrupt source bit indicates an Auto-Negotiation LP acknowledge.
0: Not source of interrupt
1: Auto-Negotiation LP acknowledge
INT2
This interrupt source bit indicates a Parallel Detection fault.
0: Not source of interrupt
1: Parallel Detection fault
INT1
This interrupt source bit indicates an Auto-Negotiation page received.
0: Not source of interrupt
1: Auto-Negotiation page received
RESERVED
Port x PHY Interrupt Source Flags Register (PHY_INTERRUPT_SOURCE_x)
This read-only register is used to determine to source of various Port x PHY interrupts. All interrupt
source bits in this register are read-only and latch high upon detection of the corresponding interrupt
(if enabled). A read of this register clears the interrupts. These interrupts are enabled or masked via
the
Port x PHY Mode Control/Status Register
Port x PHY Interrupt Mask Register
Index (decimal): 29
DESCRIPTION
DATASHEET
has been set.
(PHY_INTERRUPT_MASK_x).
Energy On (ENERGYON)
209
Size:
16 bits
bit of
RO/LH
RO/LH
RO/LH
RO/LH
RO/LH
RO/LH
RO/LH
TYPE
RO
RO
Revision 1.4 (07-07-10)
DEFAULT
0b
0b
0b
0b
0b
0b
0b
-
-