PN5120A0HN/C1 NXP Semiconductors, PN5120A0HN/C1 Datasheet - Page 27

• Manufacturer Part Number: PN5120A0HN/C1
• Description: Transmission Module 40-Pin HVQFN EP T/R
• Manufacturer: NXP Semiconductors

Specifications of PN5120A0HN/C1

• Package: 40HVQFN EP
• Operating Temperature: -30 to 85 °C

NXP Semiconductors
PN512
Product data sheet
COMPANY PUBLIC
9.2.1.9 Status2Reg
Contains status bits of the Receiver, Transmitter and Data mode detector.
Table 32.
Table 33.
Bit
7
6
5
4
3
2 to 0
Access
Rights
Symbol
TempSensClear
I
-
TargetActivated
MFCrypto1On
Modem State
TempSensClear I
2
CForceHS
Status2Reg register (address 08h); reset value: 00h, 00000000b
Description of Status2Reg bits
r/w
All information provided in this document is subject to legal disclaimers.
7
Rev. 3.6 — 10 March 2011
2
Description
Set to logic 1, this bit clears the temperature error, if the temperature
is below the alarm limit of 125 °C.
I
High-speed mode independent of the I
I
Reserved for future use.
Set to logic 1 if the Select command or if the Polling command was
answered. Note: This bit can only be set during the AutoColl
command in Passive Communication mode.
Note: This bit is cleared automatically by switching off the external
RF field.
This bit indicates that the MIFARE Crypto1 unit is switched on and
therefore all data communication with the card is encrypted.
This bit can only be set to logic 1 by a successful execution of the
MFAuthent Command. This bit is only valid in Reader/Writer mode
for MIFARE cards. This bit shall be cleared by software.
machines.
Value
000
001
010
011
100
101
110
ModemState shows the state of the transmitter and receiver state
2
2
CForceHS
C input filter settings. Set to logic 1, the I
C input filter is set to the used I
r/w
111336
6
Description
IDLE
Wait for StartSend in register BitFramingReg
TxWait: Wait until RF field is present, if the bit TxWaitRF is
set to logic 1. The minimum time for TxWait is defined by the
TxWaitReg register.
Sending
RxWait: Wait until RF field is present, if the bit RxWaitRF is
set to logic 1. The minimum time for RxWait is defined by the
RxWaitReg register.
Wait for data
Receiving
RFU
5
0
TargetActivated MFCrypto1On Modem State
dy
4
2
C protocol.
2
C protocol. Set to logic 0, the
2
C input filter is set to the
Transmission module
dy
3
© NXP B.V. 2011. All rights reserved.
PN512
2
r
27 of 125
1
r
0
r