ISP1507B1HNTM STEricsson, ISP1507B1HNTM Datasheet - Page 45

• Manufacturer Part Number: ISP1507B1HNTM
• Manufacturer: STEricsson

Specifications of ISP1507B1HNTM

• Lead Free Status / RoHS Status: Compliant

CD00269905
Product data sheet
10.12.1 OTG comparators
10.12.2 Pull-up and pull-down resistors
10.12.3 ID detection
10.12.4 V
10.13 Serial modes
The ISP1507x1 provides comparators that conform to On-The-Go Supplement to the
USB 2.0 Specification Rev. 1.3 requirements of V
and V
V
are communicated to the link by RXCMDs as described in
comparators is described in
The USB resistors on DP and DM can be used to initiate data-line pulsing SRP. The link
must set the required bus state using mode settings in
The ISP1507x1 provides an internal pull-up resistor to sense the value of the ID pin. The
pull-up resistor must first be enabled by setting the ID_PULLUP register bit to logic 1. If
the value on ID has changed, the ISP1507x1 will send an RXCMD or interrupt to the link
by time t
has not changed.
A pull-up resistor, R
allowed to charge V
the V
A pull-down resistor, R
whenever the A-device turns off the V
resistor to ensure V
For details, refer to On-The-Go Supplement to the USB 2.0 Specification Rev. 1.3.
The ISP1507x1 supports both 6-pin serial mode and 3-pin serial mode, controlled by
bits 6PIN_FSLS_SERIAL and 3PIN_FSLS_SERIAL of the INTF_CTRL register (see
Section
Rev. 1.1, Section 3.10.
Figure 20
respectively.
B_SESS_VLD
BUS
BUS
B_SESS_END
charge and discharge resistors
11.1.3). For details, refer to UTMI+ Low Pin Interface (ULPI) Specification
ID
power.
and
. If the link does not receive any RXCMD or interrupt by t
. Comparators are described in
Figure 21
. In this data sheet, V
BUS
UP(VBUS)
BUS
DN(VBUS)
Rev. 03 — 26 July 2010
is below V
above the session valid threshold to request the host to turn on
provide examples of 6-pin serial mode and 3-pin serial mode,
, is provided to perform V
Section 11.1.5
, is provided for a B-device to discharge V
B_SESS_END
BUS
A_SESS_VLD
ISP1507A1; ISP1507B1
power. The B-device can use the pull-down
to
Section
Section
before starting a session.
A_VBUS_VLD
and V
8.6.2. Changes in comparator values
BUS
11.1.8.
Table
B_SESS_VLD
ULPI HS USB OTG transceiver
pulsing SRP. A B-device is
Section
, V
8.
A_SESS_VLD
10.5.2.2. Control over
ID
are combined into
© ST-ERICSSON 2010. All rights reserved.
, then the ID value
BUS
, V
. This is done
B_SESS_VLD
45 of 78
,