DEMO9S08LIN Freescale, DEMO9S08LIN Datasheet - Page 93

• Manufacturer Part Number: DEMO9S08LIN
• Manufacturer: Freescale

Specifications of DEMO9S08LIN

• Lead Free Status / RoHS Status: Compliant

1
2
6.2.6.2
Slew rate control can be enabled for each port pin by setting the corresponding bit in the slew rate control
register (PTCSEn). When enabled, slew control limits the rate at which an output can transition in order
to reduce EMC emissions. Slew rate control has no effect on pins which are configured as inputs.
6.2.6.3
An output pin can be selected to have high output drive strength by setting the corresponding bit in the
drive strength select register (PTCDSn). When high drive is selected a pin is capable of sourcing and
sinking greater current. Even though every I/O pin can be selected as high drive, the user must ensure that
the total current source and sink limits for the chip are not exceeded. Drive strength selection is intended
to affect the DC behavior of I/O pins. However, the AC behavior is also affected. High drive allows a pin
to drive a greater load with the same switching speed as a low drive enabled pin into a smaller load.
Because of this the EMC emissions may be affected by enabling pins as high drive.
Freescale Semiconductor
PTCSE[7:0]
PTCSE7 has no effect on the input-only PTC7 pin.
Reads of PTCD6 always return the contents of PTCD6, regardless of the value stored in the bit PTCDD6.
Reset
Field
7:0
W
R
PTCSE7
Output Slew Rate Control Enable (
Output Drive Strength Select (
Slew Rate Control Enable for Port C Bits — For port C pins that are outputs, these read/write control bits
determine whether the slew rate controlled outputs are enabled. For port C pins that are configured as inputs,
these bits are ignored.
0 Slew rate control disabled.
1 Slew rate control enabled.
1
7
1
PTCSE6
Figure 6-24. Slew Rate Control Enable for Port C (PTCSE)
1
6
MC9S08LC60 Series Data Sheet: Technical Data, Rev. 4
2
Table 6-14. PTCSE Field Descriptions
PTCSE5
1
5
PTCSE4
1
4
PTCDS)
Description
PTCSE)
PTCSE3
3
1
PTCSE2
1
2
Chapter 6 Parallel Input/Output
PTCSE1
1
1
PTCSE0
1
0
93