CS1W-CN625 Omron, CS1W-CN625 Datasheet - Page 67

• Manufacturer Part Number: CS1W-CN625
• Description: CBL,PROG
• Manufacturer: Omron

Specifications of CS1W-CN625

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Note
A local network table must be registered in the CPU Unit when the target PLC has
more than one Network Communications Unit, except in the case outlined below.
Even if an online connection is made to a PLC, it will not be possible to upload or
download the network configurations unless a local network table is registered.
If the relay PLC has more than one Network Communications Unit (see note 1), it is
normally necessary to create and transfer a local network table (see note 2).
Select Tools − Start Routing Table to start the Routing Table Component, set the
local network table, and download it to the relay PLC.
Overall Procedure
Network Configuration Example
Transfer the local network table to the relay PLC
Connect to a Communications Unit/port to
Note 1: Network Communications Units include Ethernet Units, Controller Link Units,
Note 2: The local network table is one of the routing tables. It lists the unit numbers and
Computer running CX-Integrator
Connect online to the relay PLC.
Create the local network table.
Upload the network structure.
via the serial connection.
Start the CX-Integrator.
Direct serial or
network connection
enable accessing it.
SYSMAC LINK Units, DeviceNet Units, and FL-net Units. Serial Communications
Boards/Units are not included except in the following case: If serial ports are regis-
tered in the local network table to treat them as networks, the serial ports must be
treated as Network Communications Units, including the serial ports on the CPU
Unit.
network addresses of the network Communications Units.
Number of Network Communications
More than 1
More than One Network Communications Unit
(Ethernet Unit, Controller Link Unit, SYSMAC
LINK Unit, DeviceNet Unit, or FL-net Unit)
Only 1
Units
Relay PLC (= target PLC)
CS/CJ-series PLC
Example: Select Component − Auto Online
from the menu bar to automatically connect
online using a serial connection.
Select Tools - Start Routing Table from the
menu bar.
Create the local network table and select
Option − Transfer to PLC.
Right-click the desired network in the Online
Connection Information Window and select
Connect from the pop-up menu.
Right-click and select Transfer [Network to
PC].
Local network table registration
Not required
Required
At least one network address must be
assigned in the local network table.
2-1
The local network table must be transferred
when the relay PLC is still the target PLC to
register the correspondence between unit
numbers and network addresses.
Basic Procedures
Required
2-3