CS1W-CN625 Omron, CS1W-CN625 Datasheet - Page 129

• Manufacturer Part Number: CS1W-CN625
• Description: CBL,PROG
• Manufacturer: Omron

Specifications of CS1W-CN625

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

3-2 Setting the Routing Tables
3-2-4 Checking Routing Tables for Errors
3-2-4
3-20
Checking Routing Tables for Errors
Crossing Network Layers with Version 2.0 and Later CS/CJ-series Units
With Version 2.0 and later CS/CJ-series Units, FINS commands can cross over up to
8 network layers (see note), including the local network.
Applicable Networks:
Not all networks can be crossed up to 8 times. Only the following two kinds of
networks can be crossed up to 8 times. (The networks can be crossed in any
combination.)
Controller Link
Ethernet
Note: Operation through DeviceNet networks may not be dependable.
Configuration of Compatible Models:
Both the node sending the FINS command and the target node must be Version 2.0 or
later CS/CJ-series Units. Intermediate nodes may be PLC models other than Version
2.0 or later CS/CJ-series Units, i.e., PLC models that support a maximum of 3 network
layer crossings.
The error check function checks whether the created local network table and relay
network table have been set correctly.
1. Select Options – Check Routing Table for errors in the PLC Routing Table
Serial
connection
This does not count as a layer crossing.
Window.
The results of the error check will be displayed.
Normal Result:
Results when Errors Were Detected:
For details on error messages displayed in the routing table Error List Check Dialog
Box, refer to Appendix Data Link Table and Routing Table Error Messages.
Node
FINS command
or
sendin g
Network 1
Network layers = 1
Network 2
Network layers = 2
Network 3
Network layers = 3
Network 4
Network layers = 3
Network 7
Network layers = 7
Network 8
FINS command
destination