AT91SAM9261-CJ-999 Atmel, AT91SAM9261-CJ-999 Datasheet - Page 617

• Manufacturer Part Number: AT91SAM9261-CJ-999
• Description: IC MCU ARM9 ULTRA LP 217LFBGA
• Manufacturer: Atmel
• Series: AT91SAMr

Specifications of AT91SAM9261-CJ-999

• Core Processor: ARM9
• Core Size: 16/32-Bit
• Speed: 190MHz
• Connectivity: EBI/EMI, I²C, MMC, SPI, SSC, UART/USART, USB
• Peripherals: DMA, LCD, POR, PWM, WDT
• Number Of I /o: 96
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: ROM
• Ram Size: 192K x 8
• Voltage - Supply (vcc/vdd): 1.08 V ~ 1.32 V
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 217-LFBGA
• For Use With: AT91SAM9261-EK - KIT EVAL FOR AT91SAM926EJ-SAT91SAM-ICE - EMULATOR FOR AT91 ARM7/ARM9
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Data Converters: -

6062M–ATARM–23-Mar-09
Figure 38-2. Datapath Structure
This module transforms the data read from the memory into a format according to the LCD mod-
ule used. It has four different interfaces: the input interface, the output interface, the
configuration interface and the control interface.
The datapath can be characterized by two parameters: initial_latency and cycles_per_data. The
parameter initial_latency is defined as the number of LCDC Core Clock cycles until the first data
is available at the output of the datapath. The parameter cycles_per_data is the minimum num-
ber of LCDC Core clock cycles between two consecutive data at the output interface.
• The input interface connects the datapath with the DMA controller. It is a dual FIFO interface
• The output interface is a 24-bit data bus. The configuration of this interface depends on the
• The configuration interface connects the datapath with the configuration block. It is used to
• The control interface connects the datapath with the timing generation block. The main
with a data bus and two push lines that are used by the DMA controller to fill the FIFOs.
type of LCD used (TFT or STN, Single or Dual Scan, 4-bit, 8-bit, 16-bit or 24-bit interface).
select between the different datapath configurations.
control signal is the data-request signal, used by the timing generation module to request
new data from the datapath.
Serializer
Dithering
Palette
Output
Shifter
FIFO
Input Interface
Output Interface
AT91SAM9261 Preliminary
Configuration IF
Control Interface
617