HD64F2145BTE20 Renesas Electronics America, HD64F2145BTE20 Datasheet - Page 530

• Manufacturer Part Number: HD64F2145BTE20
• Description: IC H8S MCU FLASH 256K 100-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2100r

Specifications of HD64F2145BTE20

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: I²C, IrDA, SCI, X-Bus
• Peripherals: PWM, WDT
• Number Of I /o: 74
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Section 16 I
Notes on Initialization:
The value of the BBSY bit cannot be modified directly by this module clear function, but since the
stop condition pin waveform is generated according to the state and release timing of the SCL and
SDA pins, the BBSY bit may be cleared as a result. Similarly, state switching of other bits and
flags may also have an effect.
To prevent problems caused by these factors, the following procedure should be used when
initializing the IIC state.
1. Execute initialization of the internal state according to the setting of bits CLR3 to CLR0 or
2. Execute a stop condition issuance instruction (write 0 to BBSY and SCP) to clear the BBSY
3. Re-execute initialization of the internal state according to the setting of bits CLR3 to CLR0 or
4. Initialize (re-set) the IIC registers.
Rev. 3.00 Mar 21, 2006 page 474 of 788
REJ09B0300-0300
Interrupt flags and interrupt sources are not cleared, and so flag clearing measures must be
taken as necessary.
Basically, other register flags are not cleared either, and so flag clearing measures must be
taken as necessary.
When initialization is executed by DDCSWR, the write data for bits CLR3 to CLR0 is not
retained. To perform IIC clearance, bits CLR3 to CLR0 must be written to simultaneously
using an MOV instruction. Do not use a bit manipulation instruction such as BCLR.
Similarly, when clearing is required again, all the bits must be written to simultaneously in
accordance with the setting.
If a flag clearing setting is made during transmission/reception, the IIC module will stop
transmitting/receiving at that point and the SCL and SDA pins will be released. When
transmission/reception is started again, register initialization, etc., must be carried out as
necessary to enable correct communication as a system.
ICE bit clearing.
bit to 0, and wait for two transfer rate clock cycles.
ICE bit clearing.
2
C Bus Interface (IIC) (Optional)