ST7FLITEUS5B6 STMicroelectronics, ST7FLITEUS5B6 Datasheet - Page 82

• Manufacturer Part Number: ST7FLITEUS5B6
• Description: MCU 8BIT 1KB FLASH 128KB 8-DIP
• Manufacturer: STMicroelectronics
• Series: ST7r

Specifications of ST7FLITEUS5B6

• Core Processor: ST7
• Core Size: 8-Bit
• Speed: 8MHz
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 5
• Program Memory Size: 1KB (1K x 8)
• Program Memory Type: FLASH
• Ram Size: 128 x 8
• Voltage - Supply (vcc/vdd): 2.4 V ~ 5.5 V
• Data Converters: A/D 5x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 8-DIP (0.300", 7.62mm)
• Controller Family/series: ST7
• No. Of I/o's: 5
• Ram Memory Size: 128Byte
• Cpu Speed: 8MHz
• No. Of Timers: 2
• Rohs Compliant: Yes
• For Use With: 497-6403 - BOARD EVAL 8BIT MICRO + TDE1708497-6407 - BOARD EVAL FOR VACUUM CLEANER497-5861 - EVAL BRD POWER MOSFET/8PIN MCU497-5858 - EVAL BOARD PLAYBACK ST7FLITE497-5515 - EVAL BOARD PHASE CTRL DIMMER497-5049 - KIT STARTER RAISONANCE ST7FLITE497-5046 - KIT TOOL FOR ST7/UPSD/STR7 MCU
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Connectivity: -
• Other names: 497-5636-5

On-chip peripherals
10.3.5
10.3.6
Note:
82/136
Interrupts
None.
Register description
Control/Status register (ADCCSR)
Reset value: 0000 0000 (00h)
A write to the ADCCSR register (with ADON set) aborts the current conversion, resets the
EOC bit and starts a new conversion.
Table 32.
AIN0
AIN1
AIN2
AIN3
AIN4
EOC
7
Bits 4:3 Reserved. Must be kept cleared.
Bits 2:0 CH[2:0] Channel Selection
Bit 7 EOC End of Conversion
Bit 6 SPEED ADC clock selection
Bit 5 ADON A/D Converter on
Channel selection
SPEED
This bit is set by hardware. It is cleared by software reading the ADCDRH register.
0: Conversion is not complete
1: Conversion complete
This bit is set and cleared by software. It is used together with the SLOW bit to
configure the ADC clock speed. Refer to the table in the SLOW bit description.
This bit is set and cleared by software.
0: A/D converter is switched off
1: A/D converter is switched on
These bits are set and cleared by software. They select the analog input to convert.
Channel pin
ADON
Read/Write (Except bit 7 read only)
0
0
0
0
0
0
1
CH2
CH2
ST7LITEUS2, ST7LITEUS5
0
0
1
1
0
CH1
CH1
0
1
0
1
0
CH0
CH0
0