HC230F1020 Altera, HC230F1020 Datasheet - Page 101

• Manufacturer Part Number: HC230F1020
• Manufacturer: Altera

Specifications of HC230F1020

• Lead Free Status / RoHS Status: Not Compliant

Altera Corporation
September 2008
Note to
(1)
(Medium)
Table 5–1. HardCopy II Device Resource Guide Color Legend
Orange
(None)
(High)
Green
Color
Red
The package resource is constrained by the Stratix II FPGA for which the design was compiled. Only vertical
migration devices within the same package are able to migrate to HardCopy II devices.
Table
The design can migrate to the Hardcopy II
package and the design has been fitted with
target device migration enabled in the
HardCopy II Companion Device dialog box.
The design can migrate to the Hardcopy II
package. However, the design has not been fitted
with target device migration enabled in the
HardCopy II Companion Device dialog box.
The design cannot migrate to the Hardcopy II
package.
5–1:
f
Package Resource
The HardCopy II architecture consists of an array of fine-grained HCells,
which are used to build logic equivalent to Stratix II adaptive logic
modules (ALMs) and digital signal processing (DSP) blocks. The DSP
blocks in HardCopy II devices match the functionality of the Stratix II
DSP blocks, though timing of these blocks is different than the FPGA DSP
blocks because they are constructed of HCell Macros. The M4K and
M-RAM memory blocks in HardCopy II devices are equivalent to the
Stratix II memory blocks. Preliminary timing reports of the HardCopy II
device are available in the Quartus II software. Final timing results of the
HardCopy II device are provided by the HardCopy Design Center after
back-end migration is complete.
For more information about the HardCopy II device resources, refer to
the Introduction to HardCopy II Devices and the Description, Architecture
and Features chapters in the HardCopy II Device Family Data Sheet in the
HardCopy Series Handbook.
(1)
The resource quantity is within the range of the
HardCopy II device and the design can likely
migrate if all other resources also fit.
You are still required to compile the HardCopy II
revision to make sure the design is able to route
and migrate all other resources.
The resource quantity is within the range of the
HardCopy II device. However, the resource is at
risk of exceeding the range for the HardCopy II
package.
If your target HardCopy II device falls in this
category, compile your design targeting the
HardCopy II device as soon as possible to check
if the design fits and is able to route and migrate
all other resources. You may need to migrate to a
larger device.
The resource quantity exceeds the range of the
HardCopy II device. The design cannot migrate
to this HardCopy II device.
HardCopy II Device Resource Guide
Device Resources
5–9