ATSAM3S-EK Atmel, ATSAM3S-EK Datasheet - Page 550

• Manufacturer Part Number: ATSAM3S-EK
• Description: KIT EVAL FOR ATSAM3S4C
• Manufacturer: Atmel
• Series: SAM3Sr
• Type: MCUr

Specifications of ATSAM3S-EK

• Contents: Board, Cables, Power Supply
• Silicon Manufacturer: Atmel
• Core Architecture: ARM
• Core Sub-architecture: Cortex-M3
• Kit Contents: Board
• Features: TFT Colour LCD Display, SD/MMC Interface
• Svhc: No SVHC (15-Dec-2010)
• Rohs Compliant: Yes
• For Use With/related Products: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

29.7.8
29.7.9
550
550
SAM3S Preliminary
SAM3S Preliminary
Loop Mode
Interrupt
Note:
Figure 29-15. Receive Frame Format in Continuous Mode
Note:
The receiver can be programmed to receive transmissions from the transmitter. This is done by
setting the Loop Mode (LOOP) bit in SSC_RFMR. In this case, RD is connected to TD, RF is
connected to TF and RK is connected to TK.
Most bits in SSC_SR have a corresponding bit in interrupt management registers.
The SSC can be programmed to generate an interrupt when it detects an event. The interrupt is
controlled by writing SSC_IER (Interrupt Enable Register) and SSC_IDR (Interrupt Disable Reg-
ister) These registers enable and disable, respectively, the corresponding interrupt by setting
and clearing the corresponding bit in SSC_IMR (Interrupt Mask Register), which controls the
generation of interrupts by asserting the SSC interrupt line connected to the NVIC.
Figure 29-16. Interrupt Block Diagram
1. STTDLY is set to 0. In this example, SSC_THR is loaded twice. FSDEN value has no effect on
1. STTDLY is set to 0.
the transmission. SyncData cannot be output in continuous mode.
TXBUFE
ENDTX
RXBUFF
ENDRX
PDC
RD
Transmitter
Receiver
Start = Enable Receiver
TXEMPTY
RXSYNC
TXSYNC
OVRUN
To SSC_RHR
RXRDY
TXRDY
DATLEN
Data
SSC_IER
To SSC_RHR
Set
DATLEN
SSC_IMR
Data
Interrupt
Control
SSC_IDR
Clear
SSC Interrupt
6500C–ATARM–8-Feb-11
6500C–ATARM–8-Feb-11