EQ-SFM-MAX-V1.3 Equinox Technologies, EQ-SFM-MAX-V1.3 Datasheet - Page 77

• Manufacturer Part Number: EQ-SFM-MAX-V1.3
• Description: MODULE FOR PPM3-MK2 I/O DRIVER
• Manufacturer: Equinox Technologies

Specifications of EQ-SFM-MAX-V1.3

• Accessory Type: I/O Driver Module
• For Use With/related Products: PPM3-MK2
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 483-1013

2. Test the Project in Equinox Development Suite (Target System disconnected)
66
•
•
•
•
•
•
•
•
3. Connect the Target System to the programmer
Launch the Project in EDS (Development Mode)
Select the <Target Power Supply> tab
With your Target System DISCONNECTED, place a Volt Meter across the Target Vcc (TVCC)
and GROUND terminals of the programmer (on the I/O Connector Module)
Click the <Power Up> button in EDS
The programmer should now output the specified ‘Target Voltage’ on the ‘TVCC’ pin of the
programmer IO-CON module.
Measure the voltage across the Target Vcc ‘TVCC’ and GROUND terminals of the
programmer.
If the voltage is within the limits specified in the project, click <Power Down> to remove power
to the Target System and go to step (3).
If the voltage is outside the limits specified in the project, adjust the tolerance settings and
then repeat step (2).
•
•
•
•
the Power Supply settings are now displayed
the programmer <BUSY> LED should now illuminate
the ‘Target Vcc’ LED on the I/O Connector Module should now illuminate
Connect the Target System to the programmer via an ISP Cable, Fast Connect connectors
or wire-wrap connectors.
Remove the ‘Vcc Option Link’ on the I/O Connector Module (labelled J6 or J28).
Check that you have a zero ohm connection between the Target Vcc (Vout) of the
programmer and the Vcc line of the Target System.
Using a DVM, check that there are no shorts between the Target_Vcc and Target Ground
PPM3 MKII Programmer - User Guide - V1.04 - 10
th
May 2008