EQ-SFM-MAX-V1.3 Equinox Technologies, EQ-SFM-MAX-V1.3 Datasheet - Page 21

• Manufacturer Part Number: EQ-SFM-MAX-V1.3
• Description: MODULE FOR PPM3-MK2 I/O DRIVER
• Manufacturer: Equinox Technologies

Specifications of EQ-SFM-MAX-V1.3

• Accessory Type: I/O Driver Module
• For Use With/related Products: PPM3-MK2
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 483-1013

1.6 Programmer Specifications
The table below details the hardware specifications for the programmer. Please refer to the stated
section for further information about any specific parameter.
#
1
2
3
4
5
6
7
8
9
10
Parameter
Target Device
Support
Target Device
Programming
Interfaces
Operating modes
On-board FLASH
Memory Store
Project storage in
Memory Store
Keypad entry
Status LED’s
Programmer Display 2 x 16 Back-lit LCD
Target Vcc
Voltage Detection
LED
Description / comment
See Device Support List
The programmer supports the following programming
interfaces:
The programmer supports the following operating modes:
32 Mbits (4 MBytes) FLASH Memory
4 x Push Button - <YES>, <NO>, <UP>, <Down>
This LED is located on the I/O-CON Module:
64 x Programming Projects
•
•
•
•
•
•
•
•
•
•
•
•
•
•
i.
ii.
•
•
Atmel Low Voltage SPI
Atmel High Voltage SPI (+12V Vpp)
Atmel AVR JTAG (chargeable update)
Atmel (formerly Temic) 8051 Boot loader ISP
Philips (NXP) 8051 - Boot Loader ISP
Generic I2C (SDA + SCL)
Development Mode (PC controlled)
Project Upload Mode (PC controlled)
Standalone Mode - Keypad + LCD operation
Standalone Mode – Automatic Target Connect /
Disconnect Sensing
Standalone Mode - Remote Controlled via ‘ASCII Text
Communications’ RS-232 Serial Protocol
Standalone Mode - Remote Controlled via 4-wire TTL
Remote Control Port
PC controlled via ISP-PRO software (chargeable
upgrade)
PC controlled via ConsoleEDS utility (chargeable
upgrade)
Target Vcc (POWER) LED will light when Target Vcc is
detected.
Threshold detection voltage: approx 3.1V
board on a Test Fixture via the ‘Remote System
Status’ port.
3 x Status LED’s located on the programmer:
3 x remote Status LED’s can also be connected off-
<PASS>, <BUSY>, <FAIL>
PPM3 MKII Programmer - User Guide - V1.04 - 10
th
May 2008
Refer
to
section
1.7.1
1.7.2
2.4