EQ-SFM-MAX-V1.3 Equinox Technologies, EQ-SFM-MAX-V1.3 Datasheet - Page 36

• Manufacturer Part Number: EQ-SFM-MAX-V1.3
• Description: MODULE FOR PPM3-MK2 I/O DRIVER
• Manufacturer: Equinox Technologies

Specifications of EQ-SFM-MAX-V1.3

• Accessory Type: I/O Driver Module
• For Use With/related Products: PPM3-MK2
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 483-1013

2.4 Programmer Operating Modes
The PPM3 programmer can be controlled in various different ways as detailed in the table below:
# Programmer Mode
1 Development Mode
2 Standalone -
3 Standalone -
4 Standalone -
5 Target System auto-
PPM3 MKII Programmer - User Guide - V1.04 - 10
Keypad Mode
ASCII Text
Communications
Control
4-Wire TTL Control
detect mode
Control
Software
EQTools -
EDS
None
Any Terminal
Emulation
Software
None
None
U/
S
S In this mode, the programmer is controlled
S In this mode, the programmer is not
S This protocol can be used to control an
S The PPM3 programmer can be controlled
S The PPM3 programmer is capable of
Functional description
by EQTools - Equinox Development Suite
(EDS). EDS allows you to read/write the
target device FLASH / EEPROM / FUSE /
LOCK bits interactively under PC control
without uploading a ‘Programming Project’
to the programmer.
connected to a PC and can program a
single ‘Programming Project’ into the Target
Device when the <YES> key is pressed. (A
valid project must have been previously
uploaded to the programmer using EQTools
– Upload Wizard.)
Equinox programmer from a Remote
Application or Remote System using a
simple set of ASCII serial commands. This
protocol is ideal for controlling Equinox
programmers from any Remote System
which features an RS-232 serial port and
which can operate at a fixed baud rate of
38,400.
using a 4-wire TTL signalling protocol as
shown in the diagram below. This control
method is ideal for interfacing the
programmer In-Circuit Testers (ICT’s) or
other production equipment which does not
have an RS-232 port.
automatically detecting when a Target
System is connected to / disconnected from
the programmer. This can be used to trigger
the execution of a Programming Project in
Standalone Mode.
th
May 2008
Refer
to
section
2.5
2.6
2.7
2.8
2.9
25