EQ-SFM-MAX-V1.3 Equinox Technologies, EQ-SFM-MAX-V1.3 Datasheet - Page 48

• Manufacturer Part Number: EQ-SFM-MAX-V1.3
• Description: MODULE FOR PPM3-MK2 I/O DRIVER
• Manufacturer: Equinox Technologies

Specifications of EQ-SFM-MAX-V1.3

• Accessory Type: I/O Driver Module
• For Use With/related Products: PPM3-MK2
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 483-1013

4. Wait for the programmer to CRC check the Programming Project
LCD Display
Please note:
5. Press the RED <YES> button again to execute the Programming Project
LCD Display
6. Programming Project – PASS
If the Programming Project programs the target device without any errors:
LCD Display
PPM3 MKII Programmer - User Guide - V1.04 - 10
•
•
•
•
•
•
•
•
•
•
•
•
The programmer performs a full CRC validation check of the entire Programming Project
stored in the programmer ‘FLASH Memory Store’.
If the check is OK, the programmer goes to step (5).
If the check FAILS, the programmer will display ‘Internal Image is corrupted’. Please try re-
uploading your Project Collection and then repeat the Standalone Mode process from the
beginning.
It is possible to switch off the ‘Project CRC Image Check’ function by disabling the ‘CRC
check’ in the Programming Project.
This feature is available in EQTools build 888 or above and firmware 3.07 or above.
The Programming Project will now start to execute.
The <BUSY> LED will illuminate to denote that the programmer is active.
This may take a few seconds or a few minutes depending on the nature of the Programming
Project.
The Programming Project will either PASS or FAIL
The <PASS> LED will FLASH
The LCD will display: ‘Operation Complete OK!’
Press <YES> key to program another device
operation is displayed
Current programming
CHECKING IMAGE
COMPLETE OK
OPERATION
PAGE n
Buttons
Buttons
To abort the
programming
sequence at any
time, press
Buttons
Press
th
May 2008
Status LED
Display
Status LED
Display
Status LED
Display
37