EQ-SFM-MAX-V1.3 Equinox Technologies, EQ-SFM-MAX-V1.3 Datasheet - Page 30

• Manufacturer Part Number: EQ-SFM-MAX-V1.3
• Description: MODULE FOR PPM3-MK2 I/O DRIVER
• Manufacturer: Equinox Technologies

Specifications of EQ-SFM-MAX-V1.3

• Accessory Type: I/O Driver Module
• For Use With/related Products: PPM3-MK2
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 483-1013

3
3a
3b
3c
3d
PPM3 MKII Programmer - User Guide - V1.04 - 10
Powering the programmer / Target System
Select the required method of powering
the programmer
Powering the programmer using an
external power supply adaptor
Powering the programmer from the Target
System at +5.0V
Programmer and Target System are
Independently powered
th
May 2008
The PPM3 programmer supports the following
power supply methods:
•
•
•
•
•
•
•
•
•
•
•
•
Programmer powered from external 9.0 –
12.0V DC regulated supply (eg. mains
adaptor) – see (3b)
Programmer is powered from the Target
System at +5.0V – see (3c)
Programmer and Target System are
independently powered – see (3d).
Plug power supply jack into mating jack
socket on the rear of the programmer.
External power supply must be 9.0 to
12.0V DC regulated
Plug the mains adaptor into the mains
supply but do not switch the power on.
The Target System supplies +5.0V to the
programmer via either the ISP Cable /
Header or the screw terminal power
connectors.
The mains power supply adaptor must
NOT be used if you are powering from
the Target System.
The programmer is powered from +9.0 to
12.0V via the DC power input on the rear
panel of the programmer.
The Target System is powered from an
independent power supply.
The Vcc connection between the
programmer and Target System must be
removed.
The programmer ‘I/O Level Convertor’
must be powered at the same voltage as
the Target System. This can be set up in
the Programming Project,
19