LFE2M50E-PS-EVN Lattice, LFE2M50E-PS-EVN Datasheet - Page 27

• Manufacturer Part Number: LFE2M50E-PS-EVN
• Description: Programmable Logic IC Development Tools LatticeECP2M PCI Express Dev Kit
• Manufacturer: Lattice

Specifications of LFE2M50E-PS-EVN

• Rohs: yes
• Tool Is For Evaluation Of: LatticeECP2M-50
• Factory Pack Quantity: 1

PCIe Solutions Board Setup and Installation
LatticeECP2M PCI Express Development Kit User’s Guide
5. In the ispVM main window, double click the appropriate XCF file.
6. Click the Go button to initiate your download. You must wait while the
7. Push in the PROGRAM button on the board to program your device from
8. After programming the device, shut down and then reboot your PC. You
9. If this is the first time this demo bitstream has been run, Windows will
Observe the selected options in the Device Information dialog. The
Device Access Option should be set to SPI Flash Programming. Verify
that the File Name shows the appropriate x1 configuration, (i.e., as
opposed to x4) and select Edit Device and change the .bit file if
necessary. Go to ispVM > Options > Cable and I/O Port Setup > Cable
Type and ensure you use the USB cable type.
flash chip on the board is programmed.
Check the Chain Configuration status to see if the download received a
Pass status. A processing status bar appears to show you the progress of
the download. Upon completion, bitstream is programmed into SPI flash
memory.
SPI flash memory.
must do this so Windows recognizes the new PCI registers and loads the
proper driver.
identify the board as new hardware and the driver for that demo needs to
be loaded. The corresponding driver is in the Driver directory of each
demo. See “Installing Solutions Board Drivers” on page 15 for
instructions.
Note:
If an error about starting the device occurs during driver installation, use
the Device Manager to disable and then re-enable the board. Or, you can
reboot your PC.
Reprogramming the Solutions Board
19