LFE2M50E-PS-EVN Lattice, LFE2M50E-PS-EVN Datasheet - Page 21

• Manufacturer Part Number: LFE2M50E-PS-EVN
• Description: Programmable Logic IC Development Tools LatticeECP2M PCI Express Dev Kit
• Manufacturer: Lattice

Specifications of LFE2M50E-PS-EVN

• Rohs: yes
• Tool Is For Evaluation Of: LatticeECP2M-50
• Factory Pack Quantity: 1

PCIe Solutions Board Setup and Installation
Hardware Installation
LatticeECP2M PCI Express Development Kit User’s Guide
Figure 3: Configuration Mode Setting Dip Switches in “On” Position
The procedures in this section provide step-by-step instructions for installing
hardware and drivers to ensure proper board and PC communication and
operation. These procedures are meant to supplement the section
“Unpacking and Inspecting the Solutions Board” on page 12.
Installing the Solutions Board Hardware
After board setup, you can install the hardware. You must have administrative
privileges on Windows to perform this installation. See Appendix A for Linux
corresponding instructions.
Caution:
Lattice is not liable for any loss of data or damages that may result from the
installation of the hardware and execution of the kit demo software tools. Do
not install and operate on mission-critical systems.
To install the Lattice PCI Express Solutions Board for Windows:
1. Shut down Windows, turn off the PC and unplug the power cord.
2. Locate an available PCI Express slot. The board can be installed in any
3. Ensure that the solutions board is not connected to any external power
4. Using ESD precautions, install the LatticeECP2M PCI Express Solutions
IMPORTANT: This step is necessary because PC power supplies have
standby voltages that are present even when the PC power light and fan
are turned off. Unplugging the PC is the safest way to ensure the board
will not be “hot-swapped”.
slot that is larger than the finger edges in use, x1, x4, or x16.
supply before proceeding.
Board in the PCI Express slot in the x1 position.
Hardware Installation
13