KSZ8862-16_10 MICREL [Micrel Semiconductor], KSZ8862-16_10 Datasheet - Page 60

• Manufacturer Part Number: KSZ8862-16_10
• Description: 2-Port Ethernet Switch with Non-PCI Interface and Fiber Support
• Manufacturer: MICREL [Micrel Semiconductor]

Bank 3 EEPROM Control Register (0x02): EEPCR
To support an external EEPROM, tie the EEPROM Enable (EEEN) pin to High; otherwise, tie it to Low. If an external
EEPROM is not used, the default chip Base Address (0x300), and the software programs the host MAC address. If an
EEPROM is used in the design (EEPROM Enable pin to High), the chip Base Address and host MAC address are loaded
from the EEPROM immediately after reset. The KSZ8862M allows the software to access (read and write) the EEPROM
directly; that is, the EEPROM access timing can be fully controlled by the software if the EEPROM Software Access bit is
set.
Bank 3 Memory BIST INFO Register (0x04): MBIR
Bank 3 Global Reset Register (0x06): GRR
This register controls the global reset function with information programmed by the CPU.
Micrel, Inc.
August 2010
Bit
15-5
4
3
2-0
Bit
15-13
12
11
10-5
4
3
2-0
Bit
15-1
0
-
0
-
0x0
-
-
-
-
-
-
0
Default Value
0x0
Default Value
Default Value
0x0000
R/W
RO
RW
RO
RW
R/W
RO
RO
RO
RO
RO
RO
RO
R/W
RO
RW
Description
Reserved
EESA EEPROM Software Access
1: enable software to access EEPROM through bit 3 to bit 0.
0: disable software to access EEPROM.
EECB EEPROM Status Bit
Data Receive from EEPROM. This bit directly reads the EEDI pin.
EECB EEPROM Control Bits
Bit 2: Data Transmit to EEPROM. This bit directly controls the device’s EEDO pin.
Bit 1: Serial Clock. This bit directly controls the device’s EESK pin.
Bit 0: Chip Select for EEPROM. This bit directly controls the device’s EECS pin.
Description
Reserved
TXMBF TX Memory Bist Finish
When set, it indicates the Memory Built In Self Test completion for the TX Memory.
TXMBFA TX Memory Bist Fail
When set, it indicates the Memory Built In Self Test has failed.
Reserved
RXMBF RX Memory Bist Finish
When set, it indicates the Memory Built In Self Test completion for the RX Memory.
RXMBFA RX Memory Bist Fail
When set, it indicates the Memory Built In Self Test has failed.
Reserved
Description
Reserved
Global Soft Reset
1: software reset is active.
0: software reset is inactive.
Software reset will affect PHY, MAC, QMU, DMA, and the switch core, only the BIU (base
address registers) remains unaffected by a software reset.
60
KSZ8862-16/32MQL
M9999-081310-3.1