upd78f0103hmca1-5a4-a Renesas Electronics Corporation., upd78f0103hmca1-5a4-a Datasheet - Page 408

• Manufacturer Part Number: upd78f0103hmca1-5a4-a
• Description: 8-bit Single-chip Microcontrollers
• Manufacturer: Renesas Electronics Corporation.

<R>
A.5 Debugging Tools (Hardware)
A.5.1 When using in-circuit emulator QB-78K0KX1H
408
QB-78K0KX1H
In-circuit emulator
QB-144-CA-01
Check pin adapter
QB-80-EP-01T
Emulation probe
QB-30MC-EA-01T
Exchange adapter
QB-30MC-YS-01T
Space adapter
QB-30MC-YQ-01T
(YSPACK30BK+YQGUIDE-S3)
YQ connector
QB-30MC-HQ-01T (HSPACK30BK)
Mount adapter
QB-30MC-NQ-01T (NSPACK30BK)
Target connector
Note The QB-78K0KX1H is supplied with a power supply unit, USB interface cable, and flash memory
Remarks 1. The packed contents differ depending on the part number, as follows.
programmer PG-FPL. It is also supplied with integrated debugger ID78K0-QB as control software.
2. YSPACK30BK, YQGUIDE-S3, HSPACK30BK, and NSPACK30BK are products of TOKYO
Note
• QB-78K0KX1H-ZZZ:
• QB-78K0KX1H-T30MC: In-circuit emulator and supplied products (emulation probe, exchange
ELETECH CORPORATION.
For further information, contact: Daimaru Kogyo, Ltd. Tokyo Electronic Device Department
(TEL: [phone])
This in-circuit emulator serves to debug hardware and software when developing
application systems using the 78K0/Kx1 and 78K0/Kx1+. It corresponds to the integrated
debugger (ID78K0-QB). This emulator should be used in combination with a power
supply unit and emulation probe, and the USB is used to connect this emulator to the
host machine.
This check pin adapter is used in waveform monitoring using the oscilloscope, etc.
This emulation probe is flexible type and used to connect the in-circuit emulator and
target system.
This exchange adapter is used to perform pin conversion from the in-circuit emulator to
target connector.
This space adapter is used to adjust the height between the target system and in-circuit
emulator.
This YQ connector is used to connect the target connector and exchange adapter.
This mount adapter is used to mount the target device with socket.
This target connector is used to mount on the target system.
APPENDIX A DEVELOPMENT TOOLS
In-circuit emulator only
adapter, YQ connector, and target connector)
User’s Manual U16846EJ3V0UD