S1D13700F02 Epson Electronics America, Inc., S1D13700F02 Datasheet - Page 130

• Manufacturer Part Number: S1D13700F02
• Description: Embedded Memory Graphics Lcd Controller
• Manufacturer: Epson Electronics America, Inc.

Page 130
X42D-A-001-00
S1D13700F02
X42D-A-001-01
• REG[04h], for the Total Character Bytes Per Row bits, changed the formula from
• section 12.5.6, added new section with use cases for Horizontal Pixel Scrolling
• section 17, updated the “State of LCD Pins During Power Save Mode” table as follows:
• all changes from the last revision of the spec are highlighted in Red
• initial draft created from S1D13700F01 Spec Rev 4.03
• section 7.2, added new diagram and additional information to Note 1 about case when
• section 7.3.6, removed this section “Display Memory Access Timing for Text Mode” as
• section 7.4, updated the Power Save Mode/Display Enable Timing diagram
• section 7.4, added the following note to Power Save Mode/Display Enable Timing
• section 12.2.3 “Display Scan Timing”, removed note about possible flicker problems in
•
Revision 0.01
“0<=[TC/R]<=255” to “2<=TC/R<=255”
internal oscillator is used with external crystal
it does not apply to the S1D13700F02
section, “When using an external crystal with the internal oscillator, a delay is required
after exiting power save mode for system stabilization. For further information, refer to
Section 7.2, “Reset Timing” on page 25.”
text mode, this issue was fixed for the S1D13700F02
FPSHIFT state during display off changed to “X”
WAIT# state during display off changed to “—”
DB[7:0] state during display off changed to “—”
XCD1 pin changed to “XCD1 / XCG1”
XCD1 / XCG1 state during display off changed to “Running”
XCD1 / XCG1 state during power save mode changed to “Stopped”
Revision 1.01
Epson Research and Development
Hardware Functional Specification
Vancouver Design Center
Issue Date: 2005/11/29