AT32UC3C164C Atmel Corporation, AT32UC3C164C Datasheet - Page 442

• Manufacturer Part Number: AT32UC3C164C
• Manufacturer: Atmel Corporation

Specifications of AT32UC3C164C

• Flash (kbytes): 64 Kbytes
• Pin Count: 100
• Max. Operating Frequency: 66 MHz
• Cpu: 32-bit AVR
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 81
• Ext Interrupts: 100
• Usb Transceiver: 1
• Quadrature Decoder Channels: 2
• Usb Speed: Full Speed
• Usb Interface: Device + OTG
• Spi: 7
• Twi (i2c): 3
• Uart: 5
• Can: 2
• Lin: 5
• Ssc: 1
• Ethernet: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 16
• Adc Resolution (bits): 12
• Adc Speed (ksps): 2000
• Analog Comparators: 4
• Resistive Touch Screen: No
• Dac Channels: 4
• Dac Resolution (bits): 12
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 20
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.0 to 3.6 or 4.5 to 5.5
• Operating Voltage (vcc): 3.0 to 3.6 or 4.5 to 5.5
• Fpu: Yes
• Mpu / Mmu: Yes / No
• Timers: 6
• Output Compare Channels: 22
• Input Capture Channels: 12
• Pwm Channels: 19
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

22.6.5
Name:
Access Type:
Offset:
Reset Value:
• IDLE
• SEN: SAU Setup Mode Enable
• EN: SAU Enabled
• RTRADR: RTR Address Error
• MBERROR: Master Interface Bus Error
• URES: Unlock Register Error Status
• URKEY: Unlock Register Key Error
• URREAD: Unlock Register Read
32117C–AVR-08/11
RTRADR
31
23
15
7
-
-
-
This bit is cleared when a read or write operation to the SAU channel is started.
This bit is set when the operation is completed and no SAU bus operations are pending.
This bit is cleared when the SAU exits setup mode.
This bit is set when the SAU enters setup mode.
This bit is cleared when the SAU is disabled.
This bit is set when the SAU is enabled.
This bit is cleared when the corresponding bit in ICR is written to one.
This bit is set if, in the configuration phase, an RTR was written with an illegal address, i.e. the upper 16 bits in the address were
different from 0xFFFC, 0xFFFD, 0xFFFE or 0xFFFF.
This bit is cleared when the corresponding bit in ICR is written to one.
This bit is set if a channel access generated a transfer on the master interface that received a bus error response from the
addressed slave.
This bit is cleared when the corresponding bit in ICR is written to one.
This bit is set if an attempt was made to unlock a channel by writing to the Unlock Register while one or more error bits were set
in SR. The unlock operation was aborted.
This bit is cleared when the corresponding bit in ICR is written to one.
This bit is set if the Unlock Register was attempted written with an invalid key.
This bit is cleared when the corresponding bit in ICR is written to one.
This bit is set if the Unlock Register was read.
Status Register
MBERROR
30
22
14
6
-
-
-
SR
Read-only
0x10
0x00000400
URES
29
21
13
5
-
-
-
URKEY
28
20
12
4
-
-
-
URREAD
27
19
11
3
-
-
-
IDLE
CAU
26
18
10
2
-
-
SEN
CAS
25
17
9
1
-
-
AT32UC3C
EXP
EN
24
16
8
0
-
-
442