AT32UC3A364 Atmel Corporation, AT32UC3A364 Datasheet - Page 515

• Manufacturer Part Number: AT32UC3A364
• Manufacturer: Atmel Corporation

Specifications of AT32UC3A364

• Flash (kbytes): 64 Kbytes
• Pin Count: 144
• Max. Operating Frequency: 66 MHz
• Cpu: 32-bit AVR
• # Of Touch Channels: 32
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 110
• Ext Interrupts: 110
• Usb Transceiver: 1
• Usb Speed: Hi-Speed
• Usb Interface: Device + OTG
• Spi: 6
• Twi (i2c): 2
• Uart: 4
• Lin: 4
• Ssc: 1
• Sd / Emmc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 384
• Resistive Touch Screen: No
• Dac Channels: 2
• Dac Resolution (bits): 16
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 128
• Self Program Memory: YES
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.0 to 3.6
• Operating Voltage (vcc): 3.0 to 3.6
• Fpu: No
• Mpu / Mmu: Yes / No
• Timers: 6
• Output Compare Channels: 18
• Input Capture Channels: 12
• Pwm Channels: 12
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

Figure 24-9. Receiver Block Diagram
24.7.4
32072G–11/2011
T ra n sm itte r
D ivid e r
R X _ C L O C K
C lo ck
C lo ck
Start
The transmitter and receiver can both be programmed to start their operations when an event
occurs, respectively in the Transmit Start Selection field of the TCMR register (TCMR.START)
and in the Receive Start Selection field of the RCMR register (RCMR.START).
Under the following conditions the start event is independently programmable:
A start can be programmed in the same manner on either side of the Transmit/Receive Clock
Mode Register (TCMR/RCMR). Thus, the start could be on TX_FRAME_SYNC (transmit) or
RX_FRAME_SYNC (receive).
Moreover, the receiver can start when data is detected in the bit stream with the compare func-
tions. See
Detection on TX_FRAME_SYNC input/output is done by the Transmit Frame Sync Output
Selection field in the TFMR register (TFMR.FSOS). Similarly, detection on RX_FRAME_SYNC
input/output is done by the Receive Frame Output Sync Selection field in the RFMR register
(RFMR.FSOS).
• Continuous: in this case, the transmission starts as soon as a word is written to the THR
• Synchronously with the transmitter/receiver
• On detection of a falling/rising edge on TX_FRAME_SYNC/RX_FRAME_SYNC
• On detection of a low/high level on TX_FRAME_SYNC/RX_FRAME_SYNC
• On detection of a level change or an edge on TX_FRAME_SYNC/RX_FRAME_SYNC
register and the reception starts as soon as the receiver is enabled
M U X
C K S
Section 24.7.6
C K O
for more details on receive compare modes.
C o n tro lle r
T ri-sta te
M U X
IN V
C K I
D a ta T ra n sfe r
C o n tro lle r
T ri-sta te
C K G
R e ce ive r
O u tp u t
C lo ck
C lo ck
515