FQM1-TER01 Omron, FQM1-TER01 Datasheet - Page 39

• Manufacturer Part Number: FQM1-TER01
• Description: 5M 4COND 22AWG TPE ST MALE M12
• Manufacturer: Omron

Specifications of FQM1-TER01

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: FQM1TER01

Expanded System Configuration
1-5-2
Protocols
Host Link System
(SYSWAY Mode)
12
Host Link (SYS-
MAC WAY)
No-protocol (cus-
tom) communica-
tions
NT Links (1: N)
Peripheral Bus
(Toolbus)
Serial PLC Link
Slave
Serial Gateway
communications
Protocol (Serial
mode)
Systems
Personal computer
OMRON Programmable Termi-
nals (PTs)
General-purpose external devices
Servo Drivers
Host controllers
OMRON Programmable Termi-
nals (PTs)
CX-Programmer
OMRON PLC
OMRON Programmable Termi-
nals (PTs)
Servo Drivers
Main connection
The serial communications port mode (protocol) can be switched in the Coor-
dinator Module’s System Setup. Depending on the protocol selected, the fol-
lowing systems can be configured.
The following protocols support serial communications.
The Host Link System allows the I/O memory of the Modules to be read/writ-
ten and the operating mode to be changed from a host computer (personal
computer or Programmable Terminal (PT)) by executing Host Link commands
or FINS commands that are preceded by a Host Link header and followed by
a terminator. A Host Link System is possible for either the peripheral port or
the RS-232C port on the Coordinator Module.
Host link commands
or FINS commands
embedded in Host Link
commands
Host computer
RS-232C
Communications between the
host computer and the Module
No-protocol communications with
general-purpose devices, host
controllers, and Servo Drivers
High-speed communications with
Programmable Terminals via
direct access
Communications between the
CX-Programmer running on a
computer and the FQM1
Communications between
OMRON PLC and the FQM1
Communications between a PT
and W-series or SMARTSTEP
Servo Drivers via the FQM1
Note: Turn ON pin 2 on the DIP switch on the front of the
Use
Coordinator Module and set the serial communications
mode in the System Setup to "Host Link."
Peripheral port
Yes
(See note.)
Applicable Ports
Coordinator Module
Host Link commands/ FINS
commands
TXD(236) instruction and
RXD(235) instruction
None
None
None
FINS commands
Applicable commands and
RS-232C port
Yes
communications
instructions
Section 1-5