FQM1-TER01 Omron, FQM1-TER01 Datasheet - Page 322

• Manufacturer Part Number: FQM1-TER01
• Description: 5M 4COND 22AWG TPE ST MALE M12
• Manufacturer: Omron

Specifications of FQM1-TER01

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: FQM1TER01

Connecting the CX-Programmer
Built-in
peripheral
port
Built-in RS-
232C port D-
sub 9-pin
female
Port on
Module
Port on
Module
Computer
Windows
OS
Windows OS D-Sub 9-pin
Computer
Note
D-Sub 9-pin
male
computer
Port on
male
computer
Port on
Connecting an RS-232C Cable to the Peripheral Port
The following connection configurations can be used when connecting an RS-
232C cable to the Coordinator Module’s peripheral port.
Connecting an RS-232C Cable to the RS-232C Port
The following connection configuration can be used to connect a personal
computer to the Coordinator Module’s RS-232C port with an RS-232C cable.
Either one of the following two serial communications modes can be used
when connecting the CX-Programmer to the FQM1.
The following table lists the Programming Devices other than the CX-Pro-
grammer that can be used with CJ-series Units.
Peripheral bus
(Tool bus)
Host link (SYS-
MAC WAY)
CX-Designer
NS-Designer
CX-Motion-NCF The CX-Motion-NCF can be used to set CJ1W-
communications
Programming
Peripheral bus (Tool bus)
or Host Link (SYSMAC
WAY)
Host link (SYSMAC WAY) CS1W-CN118 +
Communications mode
Device
Serial
mode
(Network type)
Host link (SYSMAC WAY) XW2Z-200S-V
Communications mode
(Network type)
These are Programming Devices for HMI devices.
Can be connected through the Coordinator Module’s
communications port or directly connected to PT.
NCF71 Position Control Units and connected Servo
Drivers. Connect through the Coordinator Module’s
communications port.
Supports high-speed communications, so this communications
mode is normally used to connect to the CX-Programmer.
• Supports only a 1:1 connection.
• When the FQM1 is connected, the CX-Programmer can recog-
This communications mode is generally used to connect to a
host computer. Both 1:1 and 1:N connections are supported.
• Host link communications are relatively slow compared to the
• The Host Link mode supports connections through modems or
nize the baud rate and make the connection automatically.
peripheral bus mode.
optical adapters, long-distance connections using RS-422A or
RS-485 communications, and 1:N connections.
CS1W-CN118 +
XW2Z-200S-CV/
500S-CV
XW2Z-200S-V/
500S-V
Model
XW2Z-500S-V
Description
Model
Features
0.1 m +
(2 m or
5 m)
Length
2 m
5 m
Length
The XW2Z-
Cables have static-
resistant connectors.
---
---
Remarks
Section 8-2
Remarks
Connection
Supported
Supported
@@@
S-CV
295