LPC47M107S-MS Standard Microsystems (SMSC), LPC47M107S-MS Datasheet - Page 143

• Manufacturer Part Number: LPC47M107S-MS
• Manufacturer: Standard Microsystems (SMSC)

Specifications of LPC47M107S-MS

• Pin Count: 100
• Lead Free Status / RoHS Status: Compliant

Entering the Configuration State
The device enters the Configuration State when the following Config Key is successfully written to the CONFIG PORT.
Exiting the Configuration State
The device exits the Configuration State when the following Config Key is successfully written to the CONFIG PORT.
CONFIGURATION SEQUENCE
To program the configuration registers, the following sequence must be followed:
Enter Configuration Mode
To place the chip into the Configuration State the Config Key is sent to the chip's CONFIG PORT. The config key
consists of 0x55 written to the CONFIG PORT. Once the configuration key is received correctly the chip enters into the
Configuration State (The auto Config ports are enabled).
Configuration Mode
The system sets the logical device information and activates desired logical devices through the INDEX and DATA ports.
In configuration mode, the INDEX PORT is located at the CONFIG PORT address and the DATA PORT is at INDEX
PORT address + 1.
The desired configuration registers are accessed in two steps:
a. Write the index of the Logical Device Number Configuration Register (i.e., 0x07) to the INDEX PORT and then write
b. Write the address of the desired configuration register within the logical device to the INDEX PORT and then write or
Note: If accessing the Global Configuration Registers, step (a) is not required.
Exit Configuration Mode
To exit the Configuration State the system writes 0xAA to the CONFIG PORT. The chip returns to the RUN State.
Note: Only two states are defined (Run and Configuration). In the Run State the chip will always be ready to enter the
Configuration State.
the number of the desired logical device to the DATA PORT
read the configuration register through the DATA PORT.
1. Enter Configuration Mode
2. Configure the Configuration Registers
3. Exit Configuration Mode.
Config Key = <0x55>
Config Key = <0xAA>
Page 143