STM32W108B-SK STMicroelectronics, STM32W108B-SK Datasheet - Page 144

• Manufacturer Part Number: STM32W108B-SK
• Description: STARTER KIT FOR STM32W108
• Manufacturer: STMicroelectronics
• Series: STM32r
• Type: MCUr

Specifications of STM32W108B-SK

• Featured Product: STM32 Cortex-M3 Companion Products
• Contents: Board
• Silicon Manufacturer: ST Micro
• Core Architecture: ARM
• Core Sub-architecture: Cortex - M3
• Silicon Core Number: STM32
• Silicon Family Name: STM32W108xx
• Kit Contents: Board
• Features: IEEE
• Mfg Application Notes: STM32W108 Adjacent Channel Rejection Measurements
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: *
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

General-purpose timers
144/209
Bit 6 TIM_TG: Trigger Generation
Bit 4 TIM_CC4G: Capture/Compare 4 Generation
Bit 3 TIM_CC3G: Capture/Compare 3 Generation
Bit 2 TIM_CC2G: Capture/Compare 2 Generation
Bit 1 TIM_CC1G: Capture/Compare 1 Generation
Bit 0 TIM_UG: Update Generation
0: Does nothing.
1: Sets the TIM_TIF flag in the INT_TIMxFLAG register.
0: Does nothing.
1: If CC4 configured as output channel:
The TIM_CC4IF flag is set.
If CC4 configured as input channel:
The TIM_CC4IF flag is set.
The INT_TIMMISSCC4IF flag is set if the TIM_CC4IF flag was already high.
The current value of the counter is captured in TMRx_CCR4 register.
0: Does nothing.
1: If CC3 configured as output channel:
The TIM_CC3IF flag is set.
If CC3 configured as input channel:
The TIM_CC3IF flag is set.
The INT_TIMMISSCC3IF flag is set if the TIM_CC3IF flag was already high.
The current value of the counter is captured in TMRx_CCR3 register.
0: Does nothing.
1: If CC2 configured as output channel:
The TIM_CC2IF flag is set.
If CC2 configured as input channel:
The TIM_CC2IF flag is set.
The INT_TIMMISSCC2IF flag is set if the TIM_CC2IF flag was already high.
The current value of the counter is captured in TMRx_CCR2 register.
0: Does nothing.
1: If CC1 configured as output channel:
The TIM_CC1IF flag is set.
If CC1 configured as input channel:
The TIM_CC1IF flag is set.
The INT_TIMMISSCC1IF flag is set if the TIM_CC1IF flag was already high.
The current value of the counter is captured in TMRx_CCR1 register.
0: Does nothing.
1: Re-initializes the counter and generates an update of the registers. This also clears the
prescaler counter but the prescaler ratio is not affected. The counter is cleared if center-aligned
mode is selected or if TIM_DIR=0 (up-counting), otherwise it takes the auto-reload value
(TMR1_ARR) if TIM_DIR=1 (down-counting).
Doc ID 16252 Rev 8
STM32W108CB, STM32W108HB