UPD78F9221CS-CAC-A Renesas Electronics America, UPD78F9221CS-CAC-A Datasheet - Page 105

• Manufacturer Part Number: UPD78F9221CS-CAC-A
• Description: MCU 8BIT 2KB FLASH 20PIN
• Manufacturer: Renesas Electronics America
• Series: 78K0S/Kx1+r

Specifications of UPD78F9221CS-CAC-A

• Core Processor: 78K0S
• Core Size: 8-Bit
• Speed: 10MHz
• Connectivity: LIN, UART/USART
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 15
• Program Memory Size: 2KB (2K x 8)
• Program Memory Type: FLASH
• Ram Size: 128 x 8
• Voltage - Supply (vcc/vdd): 2 V ~ 5.5 V
• Data Converters: A/D 4x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

6.4.3
counter 00 (TM00).
restarting the timer in synchronization with the edge of the signal input to the TI000 pin.
the necessary pulse width. Clear the overflow flag after checking it.
prescaler mode register 00 (PRM00) and the valid level of the TI000 or TI010 pin is detected twice, thus eliminating
noise with a short pulse width.
It is possible to measure the pulse width of the signals input to the TI000 pin and TI010 pin using 16-bit timer
There are two measurement methods: measuring with TM00 used in free-running mode, and measuring by
When an interrupt occurs, read the valid value of the capture register, check the overflow flag, and then calculate
The capture operation is not performed until the signal pulse width is sampled in the count clock cycle selected by
The basic operation setting procedure is as follows.
<1> Set the CRC00 register (see Figures 6-18, 6-21, 6-23, and 6-25 for the set value).
<2> Set the count clock by using the PRM00 register.
<3> Set the TMC00 register to start the operation (see Figures 6-18, 6-21, 6-23, and 6-25 for the set value).
Caution To use two capture registers, set the TI000 and TI010 pins.
Remarks 1. For the setting of the TI000 (or TI010) pin, see 6.3 (5) Port mode register 3 (PM3).
Setting
Pulse width measurement operations
Rising edge detection
2. For how to enable the INTTM000 (or INTTM010) interrupt, see CHAPTER 12
FUNCTIONS.
Count clock
INTTM010
Figure 6-17. CR010 Capture Operation with Rising Edge Specified
CR010
TM00
TI000
CHAPTER 6 16-BIT TIMER/EVENT COUNTER 00
N
3
User’s Manual U16898EJ6V0UD
N
2
N
1
N
N
N + 1
INTERRUPT
103