DV007003 Microchip Technology, DV007003 Datasheet - Page 89

• Manufacturer Part Number: DV007003
• Description: PROGRAMMER UNIVERSAL PROMATE II
• Manufacturer: Microchip Technology
• Series: PRO MATE® IIr
• Type: Universalr

Specifications of DV007003

• Contents: Programmer, Power Supply, Assembler/Simulator, Cable, Software and Documentation
• Positions/sockets: 1
• Lead Free Status / RoHS Status: Request inventory verification / Request inventory verification
• For Use With/related Products: PIC16C5x, PIC16Cxx and PIC17Cxx 8-Bit Micro
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Request inventory verification / Request inventory verification

4.8
 2001 Microchip Technology Inc.
Reading a Device
Using PRO MATE II with the MPLAB IDE
If you want to copy the firmware from a programmed PICmicro device into an
unprogrammed device, you can read the programmed firmware (program
memory, configuration bits, etc.) into the MPLAB IDE, and then program the
new device based on this information.
Click Read in the PRO MATE Device Programmer dialog to read the entire
device (i.e., all of program memory, configuration bits, etc.). If you want to
read selectively (e.g, part of program memory, only configuration bits), then
select PRO MATE > Read Device to open the Read Device dialog
(Figure 4.7).
Check the following settings, then click Read to read the device according to
your settings. The memory area corresponding to the checked boxes will be
read. Areas that are grayed out are not available on the device .
Start Address,
End Address
Program Memory
Configuration Bits
ID Locations
EEPROM Data
Calibration Memory
Figure 4.7: Read Device Dialog
These values default to specify the entire range of
memory for the device. Specify the memory range
you want to read.
Select this option to read the program memory
range specified by the Start Address and End
Address.
Select this option to read the configuration bits.
Select this option to read the ID locations.
For devices with data EEPROM, read the data in
the data memory into the EEPROM Memory win-
dow. Refer to the MPLAB IDE User’s Guide for
more information on data EEPROM and the
EEPROM Memory window.
For devices with calibration memory, read the data
in calibration memory into the Calibration Memory
window. For more information on calibration mem-
ory, refer to Section 3.3.
DS30082J-page 83