DV007003 Microchip Technology, DV007003 Datasheet - Page 10

• Manufacturer Part Number: DV007003
• Description: PROGRAMMER UNIVERSAL PROMATE II
• Manufacturer: Microchip Technology
• Series: PRO MATE® IIr
• Type: Universalr

Specifications of DV007003

• Contents: Programmer, Power Supply, Assembler/Simulator, Cable, Software and Documentation
• Positions/sockets: 1
• Lead Free Status / RoHS Status: Request inventory verification / Request inventory verification
• For Use With/related Products: PIC16C5x, PIC16Cxx and PIC17Cxx 8-Bit Micro
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Request inventory verification / Request inventory verification

PRO MATE II User’s Guide
Using PRO MATE II with MPLAB
DS30082J-page 4
Starting PRO MATE II
Setting Up the Device Programmer and Configuration Bits
1. Start the MPLAB IDE by double-clicking the MPLAB desktop icon or by
2. Select Options > Programmer Options > Communications Port Setup
3. If the PRO MATE II menu item is not on the MPLAB menu, you must
4. Select Options > Development Mode. Select the MPLAB-SIM or Editor
5. If you are going to use the Hex file from a project to program the device,
6. Select PRO MATE > Enable Programmer from the MPLAB menu. The
7. If you get a message stating that there is a newer PRO MATE operating
The PRO MATE Device Programmer dialog is open whenever the
programmer is enabled. Closing this dialog disables the programmer.
1. Make sure the correct device is displayed. If the device you want to pro-
2. If you want to identify the programming on a device (e.g., version con-
3. If your application runs at the extreme voltage operating range, select
4. Set the configuration bits in the Configuration Bits dialog. If you set con-
selecting Programs > Microchip MPLAB > MPLAB from your Start menu.
from the MPLAB menu. Select the COM port that the PRO MATE II is on.
select the PRO MATE II programmer. In the MPLAB desktop, select
Options > Programmer Options > Select Programmer. Select
PRO MATE Device Programmer and click OK. A message will prompt
you to restart MPLAB in order for the change to take effect. Click Yes.
MPLAB will shut down, and the PRO MATE menu will appear on the
MPLAB menu when you restart MPLAB.
Only development mode and select the device you are going to program.
Click OK.
open that project now (Project > Open Project.)
MPLAB IDE will attempt to establish communications with the
PRO MATE, and the PRO MATE Device Programmer and Configuration
Bits dialogs will appear.
system available, refer to Section 7.12 for instructions on how to update
your operating system.
gram is not listed, you must upgrade your PRO MATE II operating sys-
tem. See Section 7.12.
trol), click Device ID and edit the device ID or select unprotected check-
sum. Click OK.
the correct voltages.
figuration bits in your source code, this dialog will be updated with those
values when you rebuild your project. The values in this dialog will be
programmed into the device you program.
If the Configuration Bits dialog is not visible, click Configuration Bits in
the PRO MATE Device Programmer dialog to reopen it.
 2001 Microchip Technology Inc.