DV007003 Microchip Technology, DV007003 Datasheet - Page 86

no-image

DV007003

Manufacturer Part Number
DV007003
Description
PROGRAMMER UNIVERSAL PROMATE II
Manufacturer
Microchip Technology
Series
PRO MATE® IIr
Type
Universalr
Datasheets

Specifications of DV007003

Contents
Programmer, Power Supply, Assembler/Simulator, Cable, Software and Documentation
Positions/sockets
1
Lead Free Status / RoHS Status
Request inventory verification / Request inventory verification
For Use With/related Products
PIC16C5x, PIC16Cxx and PIC17Cxx 8-Bit Micro
Lead Free Status / RoHS Status
Lead free / RoHS Compliant, Request inventory verification / Request inventory verification
PRO MATE II User’s Guide
DS30082J-page 80
4.5.5
Checking For a Blank Device
Insert the device to be programmed into the PRO MATE II socket. Position pin
one on the device to be in the pin one position as shown on the diagram next
to the socket. Secure the device by pushing down the silver lever on the
socket.
Click on Blank in the PRO MATE Device Programmer dialog to verify that the
device is completely blank (all bits are set to a “1”). This will also verify that all
configuration bits are set to a “1” (unprogrammed) state. You can also perform
a blank check from PRO MATE II > Blank Check All.
If you are using a one-time programmable (OTP) device, some configuration
bits (e.g., oscillator bits) might have already been programmed at the factory.
Set the configuration bits to the factory settings and select PRO MATE II >
Blank Check OTP. This will check that all program memory bits are set to 1,
and that the configuration bits match the value in the dialog. An OTP device
cannot be erased and reprogrammed.
If the EPROM device is not blank, you will have to erase it before
programming or use another device. To erase a windowed device:
If the device is EEPROM/FLASH, you do not have to erase it before
reprogramming it. These devices are electrically erased before programming.
• Remove any labels covering the device window. If you do not have a
• Place the device in an Ultraviolet (UV) EPROM Eraser. The amount of
• Verify that the device is blank (i.e., perform the blank check again)
windowed device (Figure 4.5), you cannot reprogram it. A windowed
version of all EPROM devices may be ordered by requesting the JW
package.
time required to completely erase a UV erasable device depends on:
the wavelength of the light, its intensity, distance from UV source, and
the process technology of the device (the size of the memory cells).
before attempting to program it.
Figure 4.5: Windowed Device
 2001 Microchip Technology Inc.

Related parts for DV007003