DV007003 Microchip Technology, DV007003 Datasheet - Page 34

no-image

DV007003

Manufacturer Part Number
DV007003
Description
PROGRAMMER UNIVERSAL PROMATE II
Manufacturer
Microchip Technology
Series
PRO MATE® IIr
Type
Universalr
Datasheets

Specifications of DV007003

Contents
Programmer, Power Supply, Assembler/Simulator, Cable, Software and Documentation
Positions/sockets
1
Lead Free Status / RoHS Status
Request inventory verification / Request inventory verification
For Use With/related Products
PIC16C5x, PIC16Cxx and PIC17Cxx 8-Bit Micro
Lead Free Status / RoHS Status
Lead free / RoHS Compliant, Request inventory verification / Request inventory verification
PRO MATE II User’s Guide
2.7
2.8
DS30082J-page 28
Powering Up PRO MATE II
Configuring the Serial Port for PRO MATE II
Once you have connected the hardware and installed the software, you are
ready to turn on PRO MATE II. Turn the power switch on the back of the
PRO MATE II to ON. You should see the following types of messages appear
on the LCD panel on the front of the PRO MATE II:
1. PRO MATE II Hardware Self Check
2. PRO MATE II Device Programmer
3. Version number and copyright dates
4. Type of socket module or family selection options
5. Device selection options
If the message “Socket Not Supported” appears, make sure the socket
module is properly installed into PRO MATE II (see Section 2.4.1). If the
installation is correct, you may need to update the PRO MATE II operating
system for support of the installed socket module (see Section 7.12). If the
operating system is the latest update, you may have a bad socket module.
Please contact Microchip support (see General Information).
If any of the following messages appear, power off the PRO MATE II, realign
the socket module (see Section 2.4.1), then turn it back on:
At this point, you are ready to use PRO MATE II. If you are going to use PRO
MATE II with MPLAB (Windows), please refer to Chapter 4. If you are going to
use PRO MATE II with PROCMD (DOS), please refer to Chapter 5. If you are
going to use PRO MATE II in stand-alone mode, please refer to Chapter 6.
Once MPLAB is installed on your PC, you run it by one of the following
methods:
The MPLAB desktop should look like Figure 2.4.
• Tighten Socket Top
• Select Socket
• Socket Not Supported
• For Windows 3.x/NT 3.51: Double-click on the MPLAB icon.
• For Windows 95/98, Windows NT 4.0, or Windows 2000: From the
Start menu, select Programs > Microchip MPLAB > MPLAB.
 2001 Microchip Technology Inc.

Related parts for DV007003