PG-FP5-EA Renesas Electronics America, PG-FP5-EA Datasheet - Page 94

• Manufacturer Part Number: PG-FP5-EA
• Description: PROGRAMMER FLASH MEMORY UNIV
• Manufacturer: Renesas Electronics America

Specifications of PG-FP5-EA

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

PG-FP5
R20UT0008EJ0400 Rev. 4.00
Jul 15, 2010
<1> [Supply voltage] area
In this area, specify one (V
with the target device type. Basically, V
the target system. Supplying from the FP5 is possible, but the current flow is not large enough to operate the
whole target system (Refer to APPENDIX C
Therefore, supply voltage via the FP5 only when a dedicated writing adapter such as an FA adapter is used.
[Vdd[V]] box
The default V
[Vdd2[V]] box
The default V
types of V
level can also be changed by input.
[On Target] check box
Select this check box when supplying the V
The V
Caution Set the values of the V
• When V
• When V
If the target system V
Setup” will be displayed in the action log window.
If V
message “No VDD applied or Voltage is out of range” will be displayed in the action log window.
DD
pin power supply detection function varies depending on the setting of the [On Target] check box.
DD
DD
before selecting this check box. The target system may be damaged if proper values are not
set.
is outside the range of ±5% of the V
DD
DD
DD
for writing to flash memory, specify a lower voltage for V
DD2
is set to be supplied from FP5 ([On Target] check box: not selected)
is set to be supplied from the target system ([On Target] check box: selected)
level set in the PR5 file is displayed in volts (V). This level can be changed by input.
level set in the PR5 file is displayed in volts (V). If the target device specifications require two
DD
DD
) or two (V
exceeds 0.2 V before V
Figure 4-65. [Supply voltage] Area
DD
/V
DD2
DD
DD
/V
and V
voltages supplied from the target system for Vdd [V] and Vdd2 [V]
DD
DD2
/V
DD2
voltages for target device programming should be supplied from
DD2
ELECTRICAL SPECIFICATIONS OF TARGET INTERFACE).
voltages from the target system.
) voltage levels for target device programming, in accordance
DD
DD
set value immediately before communication starts, the
is supplied, the message “Target power detected! Check
CHAPTER 4 PROGRAMMING GUI USAGE
DD2
(e.g. V
DD
= 5.0 V, V
DD2
Page 94 of 240
= 3.3 V). This