PG-FP5-EA Renesas Electronics America, PG-FP5-EA Datasheet - Page 88

• Manufacturer Part Number: PG-FP5-EA
• Description: PROGRAMMER FLASH MEMORY UNIV
• Manufacturer: Renesas Electronics America

Specifications of PG-FP5-EA

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

PG-FP5
R20UT0008EJ0400 Rev. 4.00
Jul 15, 2010
<1> [Communication interface to device] area
Note FLMD0 in a single-power-supply flash memory microcontroller, or FLMD1 in a two-power-supply flash memory
Remark
Note This might be "3-wire clocked communication port, with handshake" depending on the target device.
SIO-ch0
SIO-ch1
SIO-ch2
SIO-H/S
IIC-ch0
IIC-ch1
IIC-ch2
IIC-ch3
UART-ch0
UART-ch1
UART-ch2
UART-ch3
Port-ch0
Port-ch1
Port-ch2
In this area, select the channel and speed for communication between the FP5 and target device.
[Port] list
Select the mode of communication between the FP5 and target device. The communication mode is determined
by the number of V
differs depending on the target device. Refer to the user’s manual of the target device used and select a mode.
With some devices, the channel number may start from 1. In this case, the corresponding number is shifted, for
example, ch0 shown in the screen corresponds to ch1 of the device, and the displayed channel number must be
shifted accordingly.
Item on Screen
microcontroller.
For the available communication channel, refer to the user’s manual of the target device, based on the pulse
count displayed for “Pulse number”.
Table 4-2. Channels for Communication Between FP5 and Target Device (1/2)
PP
UART (asynchronous communication port) channel 3
SIO (3-wire clocked communication port) channel 0
SIO (3-wire clocked communication port) channel 1
SIO (3-wire clocked communication port) channel 2
SIO (3-wire clocked communication port, with handshake pin)
I
I
I
I
UART (asynchronous communication port) channel 0
UART (asynchronous communication port) channel 1
UART (asynchronous communication port) channel 2
Port (pseudo 3-wire) A
Port (pseudo 3-wire) B
Port (pseudo 3-wire) C
2
2
2
2
C channel 0
C channel 1
C channel 2
C channel 3
output from the FP5 or the FLMD0
Figure 4-61. [Communication interface to device] Area
Note
Description
pulse count. The selectable communication mode
CHAPTER 4 PROGRAMMING GUI USAGE
Note
Page 88 of 240